User manual TEFAL ULTRAGLIDE DIFFUSION

[. . . ] - To restart the iron, just move it gently until the warning light stops flashing. Note : When the Auto-Stop warning light is on, it is normal for the thermostat light to be off. Thermostat indicator light. Goes out when the temperature has been reached. E F Sole plate Water tank maximum fill line Do not exceed this limit Thermostat control For choosing the ironing temperature M Setting the steam level (G) - In order to avoid water dripping from the iron onto the linen: · Turn off the steam when ironing silk or synthetic fabrics. · Set it at the minimum position for wool. G Warning ! [. . . ] The voltage of your electrical installation must correspond to that of the iron (220V-240V or 127 V depending on the model). Connecting to the wrong voltage may cause irreversible damage to the iron and will invalidate the guarantee. · This iron must always be plugged into an earthed socket. · If using a mains extension lead, ensure that it is correctly rated (10A or 13A for UK only), with an earth. · If the electrical cord becomes damaged, it must be immediately replaced by an Approved Service Centre to avoid any danger. · Never immerse your iron in water!· The appliance must be unplugged before filling or emptying the water tank. · If the appliance falls, have it checked by a professional before using it again; unseen damage may be dangerous. · The sole plate may be very hot: - Never touch it. - Always let it cool off before putting it away. - Never leave your iron unattended when it is plugged in or while the soleplate is still hot. - Always keep your iron out of the reach of children. · NEVER DISMANTLE YOUR IRON ; ALWAYS CONTACT AN APPROVED SERVICE CENTRE. This product has been designed for domestic use only. Any professional use, inappropriate use or failure to comply with the instructions, the manufacturer accepts no resposibility and the guarantee will not apply. GUARANTEE (U. K. ONLY) Details of the guarantee are shown on the guarantee card enclosed with the appliance. This guarantee does not affect your statutory rights. Should service or further information be required please contact the Tefal Customer Relations Department (see Helpline or enclosed Service Information leaflet). Do not attempt to dismantle the appliance yourself ­ this will negate the guarantee. In line with a policy of continuous product improvement, Tefal reserves the right to change product specifications without prior notice. · CLEANING THE SOLE PLATE: - While the soleplate is still just warm, clean it by rubbing it with a moist, non-metallic pad. 5- IS THERE A PROBLEM ? Problems · The iron does not heat up. · Water drips from the holes in the sole plate. Possible causes · The auto-stop safety switch has operated · Thermostat control not correctly positioned · The chosen temperature is too low and does not allow for the formation of steam. [. . . ] As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows : · The wire that is coloured GREEN & YELLOW must be connected to the terminal in the plug which is marked with the letter E, or the earth symbol , or coloured GREEN or GREEN & YELLOW. · The wire that is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured RED. · The wire that is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK. · This appliance requires a 13 amp fuse. [. . . ]