User manual TELEDEX DIAMOND

[. . . ] Insert either end of the line cord into the jack on the back of the telephone labeled TO TEL. Insert the other end of the line cord into a telephone wall outlet jack. Once your telephone is connected, place the paper faceplate over the keys. The plastic overlay slips into place by hooking the tabs on the overlay into the recessed slots located on both sides. [. . . ] If unauthorized repair is performed, registration, connection to the telephone lines and remainder of warranty period all become null and void. This equipment is hearing aid compatible. RMA PROCEDURES The following procedure should be followed with all Teledex telephone products prior to sending the telephone to the factory for repair. Please perform the tests listed below: a. Test the telephone on a different telephone jack. Test telephone with a different line cord. Test with a different handset cord (coiled cord). For two line products, please ensure that one of the line buttons is pressed (if both line buttons are in the UP position, the telephone will not operate). If the steps listed above do not provide a remedy for the suspect telephone, please place a tag on the individual telephone describing the defect. Next, call the Teledex Repair Department at (408) 574-2670, or (408) 574-2172 for an RMA number. You must have an RMA number to return products to Teledex. Kindly note: An RMA number is unique to each return shipment. Do not duplicate this number on any future shipments. SHIPPING INSTRUCTIONS: Please print the RMA number clearly on the outside of your shipping carton(s). Please ship to the following address: Teledex Corporation / RMA#___________ 6311 San Ignacio Avenue San Jose, CA 95119 FREIGHT CHARGES: The Customer is responsible for shipping products for repair to Teledex. After repair, Teledex will return telephone products to the Customer freight prepaid in the same manner in which is was sent (i. e. Freight sent to Teledex UPS Blue, will be returned via 2 day shipping). **Please note: When telephones are returned for repair due to misuse (i. e. liquid spills, abuse, or Customer modification - warranty label broken), the Customer will be charged the standard repair fee, regardless of warranty status. REQUIREMENTS OF PART 15 - FCC RULES NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communications. However, there is not a guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Relocate the telephone with the respect to the receiver. [. . . ] Rotate the mounting bracket a half turn (180 degrees) so that the mounting eyelet is facing in the same direction as the mounting eyelet located on the bottom surface of the telephone. Insert the top two retaining tabs of the mounting brackets into the mounting bracket slots located near the middle of the telephone , then firmly push down and insert the retaining tabs on the opposite side. Connect a short modular line cord into the jack on the back of the phone (labeled TO TEL. ). Route the line cord through the line cord channel. [. . . ]