User manual TELEDEX OPAL 1010S

[. . . ] OPAL 1010S The Teledex one-line speakerphone specifically OWNER'S MANUAL designed for the international hospitality industry. INCLUDED IN YOUR PACKAGE Handset Line Cord Base Unit Clear Plastic Overlay Coiled Handset Cord User Guide CONNECTING THE OPAL 1010S 1. Located on the left side of the Opal 1010S (as the phone is facing you) is a modular jack. Insert one end of the coiled handset cord into this jack (you should hear the coil cord click when properly inserted). Insert the other end of the coiled handset cord into the modular jack on the handset. [. . . ] The number selected will be the new pause timing in seconds (ie: "3" = 3 seconds). Press the STORE key. AUTO DIAL KEYS The Opal 1010S has ten (10) programmable AUTO DIAL keys. These keys can be programmed to automatically dial telephone numbers, or activate telephone system features. PROGRAMMING AUTO DIAL KEYS: The telephone must be connected to a telephone line. Lift the handset from the cradle or press the SPEAKERPHONE key. Press the recessed STORE key and release it. (Please see diagram on page 6 for key location). Enter the telephone number including PAUSE* as required. Press the AUTO DIAL key where the number is to be stored. Place the handset back in the cradle or press the SPEAKERPHONE key to disconnect. 4 CONVERTING FROM DESK TO W ALL MOUNT The Opal 1010S can be changed for wall mounting applications. The conversion is easiest when the handset and line cords are not connected. Located on the top of the telephone above the speaker grill is the wall/ desk mount clip. Remove this clip by firmly pushing upward (towards the hookswitch). Flip the clip over (top to bottom) so that the protruding edge is towards the top of the phone. Turn the Opal 1010S over so the bottom is up facing you. Place the Opal on a nonabrasive surface to prevent scratching. Locate and remove the mounting bracket, firmly push back and pull up to remove two of the four retaining tabs. Rotate the mounting bracket 180 degrees clockwise so that the mounting eyelet on the bracket is facing in the same direction as the other mounting eyelet located on the bottom of the telephone. Insert the top two retaining tabs of the mounting brackets into the mounting bracket slots (located near the middle of the telephone). Then firmly push down to insert the retaining tabs on the opposite side of the mounting bracket. Connect a short modular line cord into the jack on the back of the phone (labeled LINE). Route the line cord through the line cord channel. [. . . ] The department does not guarantee the equipment will operate to the users satisfaction. Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local telecommunications company. The equipment must also be installed using an acceptable method of connection. THE PRODUCT MAY FALL, CAUSING SERIOUS DAMAGE TO THE PRODUCT. [. . . ]