User manual TELEFUNKEN RUBY PDF 9322

[. . . ] Fr ( ), ( ), receive a CD of the best videos on the paramotor and regularly all information on the new products, technical information, etc. 2 receive a CD of the best videos on the paramotor and regularly all information on the new products, technical information, etc. Dear Pilot, You have acquired either an Adventure paramotor Funflyer Bi (motor unit + canopy), or just the Adventure motor unit for your existing paraglider. Adventure is the paramotor world’s leading equipment, and you have made the right choice. [. . . ] If the net isn ’t tight enough, do the tension again on the side of the cage you do first. Riser Bar (FUNBI102D&G) The riser bars are fixed on upper parts to the engine mast (FUNBI127) and on lower part to the tandem draw bar (FUNBI212) under the passenger seat. One rivet is fixed on each side of each riser bar for an easy pre-flight check. It need to be at the beginning of engine mast and tandem draw bar. Finish the fixation of the riser bars by the 4 safety pins FUN124. Attach at least the cage on the riser bars by the way of the cage connecting tube (FUNBI152). Removing the towing rig Remove the chain securing the towing rig (FUNBI210). Unscrew the towing rig bolt (FUNBI213) et remove the towing rig. Assembly of the passenger foot rest Assemble the foot rest, put the pin W112 and thi ghten the foo t r es t bolt (FUNBI214). C - PARAGLIDER’S HOOK POINT The riser bars (F UNBI102G&D) are equiped of 3 welded rings placed in front of the riser bar and of 1 welded ring on the back. In single seat uses, put the strap FUNBI6 inside the ring n°1 et attached your paraglider’s riserwith the carabiner FUNBI5. 5 Ampere hour and will be charged in 2 hours (engine running). If you don’t used you battry for one month or more, you need to put your battery on charge. A empty battery will be a defect battery in a few month. Using any other battery involves the cancellation of the warranty on the paramotor. It is strictly forbidden to disconnect the battery from the paramotor when the engine runs; this would definitely damage the high tension coil. Warning : always plug and unplug the battery with main switch on OFF position. The engines are tes ted and adjusted before being delivered. All bolts, nuts, cables etc have been tightened to the correct torque setting or secured with threadlocker. The position of all nuts and bolts was marked with a spot of red paint: any loosening can thus be immedi ately detected during your pr e-fligth check. It is necessary to check all this during the running in period. You will then be sure that your paramotor is perfectly safe and fit to fly. [. . . ] After, release your brake handle as smoothly as your Funflyer Bi picks up speed forward. OooOooo NB : TELEFUNKEN, their employees, associates and agents have taken great care in compiling this manual, but they cannot be held responsible for any errors or omissions. LANDING Identify your landing area well in advance. Begin your landing approach with engine off or at iddle and cut the engine between 10 to 5 me ter high. [. . . ]