User manual TELETRONICS INTERNATIONAL TT2400

[. . . ] TT5800/TT2400 User Manual 802. 11a 200mW 802. 11b/g 200mW 1 Table of Contents Disclaimers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Product Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Product Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Configuring windows for IP Networking . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Web Configuration Interface . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 Client Bridge Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 Access Point Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30 Appendix A: Warranty Policy . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50 Appendix B: RMA Policy . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 51 Appendix C: Regulatory Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 52 Appendix D: Contact Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 54 Appendix E: WDS Explained . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 55 Appendix F: TT2400/TT5800 Upgrade FAQ . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 57 Appendix G: Antenna Diversity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 59 Appendix H: Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 60 Appendix I: Key Requirement Chart. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 61 Appendix J: Glossary . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 62 2 Disclaimers No part of this documentation may be reproduced in any form or by any means or used to make any derivative work (such as translation, transformation or adaptation) without written permission from the copyright owner. All other trademarks and registered trademarks are the property of their respective owners. Statement of Conditions We may make improvements or changes in the product described in this documentation at any time. The information regarding the product in this manual is subject to change without notice. We assume no responsibility for errors contained herein or for direct, indirect, special, incidental or consequential damages with the furnishing, performance or use of this manual or equipment supplied with it, even if the suppliers have been advised about the possibility of such damages. Electronic Emission Notices This device complies with Part 15 of the FCC Rules. [. . . ] There are two sections to setup 2 RADIUS servers for the TT5800/TT2400 to connect to. At any given time the TT5800/TT2400 will connect to one RADIUS server for authentication and will use the other one as a backup if that option is configured. 802. 1X enabled Option that enables or disables remote RADIUS authentication. Authentication timeout (mins) The default value is 60(minutes). When the time expires, the device will re-authenticate with RADIUS server. RADIUS server IP address Enter the RADIUS server IP address. RADIUS server port number Port used for RADIUS, the port number must be the same as the RADIUS server`s, normally the port is 1812. 39 RADIUS server shared secret When registered with a RADIUS server, a password will be assigned. This would be the RADIUS server shared secret. MAC Address Authentication Use client MAC address for authentication with RAIDUS server. WEP Configuration Short for Wired Equivalent Privacy, a security protocol for wireless local area networks (WLANs) defined in the 802. 11b standard. WEP is designed to provide the same level of security as that of a wired LAN. Enable WEP To enable the WEP Authenticator Default WEP key to use · WEP Key 1-4 Select the key to be used as the default key. Data transmissions are always encrypted using the default key. The other keys can only be used to decrypt received data. Authentication · Open - Open system authentication involves a two-step authentication transaction sequence. The first step in the sequence is the identity assertion and request for authentication. The second step in the sequence is the authentication result. If it is "successful", the station shall be mutually authenticated. Open system authentication does not provide authentication. It provides identification using the wireless adapter's MAC address. Open system authentication is used when no authentication is required. It is the default authentication algorithm. Open system authentication uses the following process: 1. The authentication-initiating wireless client sends an IEEE 802. 11 authentication management frame that contains its identity. The receiving wireless AP checks the initiating station's identity and sends back an authentication verification frame. [. . . ] Static IP Address - A permanent IP address is assigned to a node in a TCP/IP network. Subnet Mask - Subnet Masks (SUBNET work masks) are used by IP protocol to direct messages into a specified network segment (i. e. , subnet). A subnet mask is stored in the client machine, server or router and is compared with an incoming IP ad-dress to determine whether to accept or reject the packet. SSID - SSID (Service Set Identifier) is a security measure used in WLANs. [. . . ]