User manual TELEX AUDIOCOM 1-34 HIGH RACK MOUNT KITS INSTRUCTION SHEET REV D

[. . . ] AUDIOCOMB 1-3/4" High Rack Mount Kits Instruction Sheet GENERAL DESCRIPTION These kits are specifically designed for use with the 1-3/4" high rack mounted Telex@ Audiocorn@ equipment. [. . . ] Use the nut (14) provided to mount the 5-3/8 face plates and support brackets (19) to the rack mount bracket. Use existing rack mount screws to install the equipment and bracket assembly into the rack. 2. 3. PARTS LIST The table below lists all of the parts used in the three different kits. The parts for each complete kit are shown in the figures on the back of this sheet. The Item numbers in the table refer to the balloon callouts shown in the figures. 4. Multiple 1/2 81114, and 1/2 811/2 Rack Units 1. KIT F RTS LIST ITEM 1 2 PART NUMBER 91 10-7352-000 91 10-7352-002 91 10-7353-000 91 10-7353-002 9160-7352-002 9160-7352-000 9160-7352-003 9160-7352-001 9160-7353-002 9160-7353-000 9160-7353-003 9160-7353-001 51845-038 52188-006 57881-001 700305-000 58424-001 700439-000 700438-000 DESCRIPTION 5-3W Rack Mount Bracket, Black 5-3/8 Rack Mount Bracket, Gray 1-1/4" Rack Mount Bracket, Black 1-1/4" Rack Mount Bracket, Gray 5 4 8 " Face Plate, Left, Black 5-3/8 Face Plate, Left, Gray 5-3/8" Face Plate, Right, Black 5 4 8 Face Plate, Right, Gray 1-1/4" Face Plate, Left, Black 1-1/4" Face Plate, Left, Gray 1-1/4" Face Plate, Right, Black 1-1/4" Face Plate, Right, Gray Screw, Pan Hd, 4-40 x 0. 25 Nut, Hex, 4-40 U-clip Fastener, Spring Screw, Flat Hd, 4-40 x 3/16 Bracket, Connector Bracket, Support Remove two of the existing cover mounting screws from one side of each piece of equipment. (Do not remove the covers. ) Use the screws (13) provided to fasten the rack mount bracket and support brackets (19) to the equipment chassis. When only standard depth units are used, install the U-clips (15) provided into the slots on the bottom and rear of the units, then use the screws (17) provided to install the connector brackets (18) on the top and bottom of the units. When deeper units are used with standard depth units, first use a screw (13) to mount the spring fastener (16) onto the side of the deeper unit, then slip the rear of the standard unit under the spring fastener. Install the U-clip (15) into the slot on the bottom of the units, then use the screws (17) provided to install the connector brackets (18) on the top and bottom of the units. 2. 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 3. 4. Use the nut (14) provided to mount the 5-3/8" face plate and support brackets (19)to the rack mount bracket. [. . . ] Telephone 952-884-4051 0 telex 6879045 Telexcom 0 Facsimile 952-884-0043 9350-7352-000Rev D June 2000 [. . . ]