User manual TELEX AUDIOCOM PS-1F INSTALLATION REV C

[. . . ] Model PS-1F Power Supply Installation Instructions General Description The Telex AudiocomTM Model PS-1F Power Supply mounts in a standard two-gang electrical outlet box. It may be used to power a single intercom channel containing up to 5 belt-pack headset stations. [. . . ] To locally power a speaker statino: Connect the speaker station's positive terminal to either one of the PS-1F CHANNEL terminals, and connect speaker station ground to the PS-1F SHLD terminal. The remaining CHANNEL terminal on the PS-1F is not used. On the speaker station, be sure to remove the jumper installed between the +24 and PH terminals. (This jumper is used only when the speaker station is phantom powered from the intercom channel. ) Mount the PS-1F in an electrical box using the screws provided with the unit. Output Voltage: Output Current: 38109-313 Rev C 11/2006 4. 6 IN. (114 MM) 3. 281 IN (495. 3 MM) 1. 812 IN. (46. 024 MM) Model PS-1F Dimensional Drawing 38109-313 Rev C 11/2006 Factory Service Service Information Factory Service All Audiocom equipment returns must be sent prepaid. Telex will not accept collect shipments. The following information must accompany all equipment returned for repair. 2. Factory Service Address: Telex Communications, Inc. Attn: Service Customer Assistance Customer Service Department RTS/Telex Communications, Inc. 12000 Portland Avenue South Burnsville, MN 55337 USA Telephone: 800-392-3497 Fax: 800-323-0498 3. 5. Your name, address and telephone number. Purchaser's name and address (if different from above). Copy of proof of purchase (keep your original). [. . . ] This is a guaranteed estimate - final charges will not exceed what is quoted. If payment is sent along with your estimate approval, COD charges will be avoided; otherwise, equipment will be returned to you C. O. D. 38109-313 Rev C 11/2006 [. . . ]