User manual TELTONIKA UM1000 QUICK START V0.2

[. . . ] This would make the installation and use of the device easier. Address: Zirmn g. 27, Vilnius LT-09105, Tel. : +370 5 2127472, Fax: +3705 276 1380, E-mail: info@teltonika. lt i INTRODUCTION This Quick Start Guide has been prepared for Windows XP (SP2) operating system. For installation guide on other supported operating systems, please refer to User Guide provided on CD. [. . . ] Dial-up networking is installed on your PC (OS) (this should be installed with OS by default). TCP/IP protocol is installed on your PC (it should be present in your OS by default). i INSTALLING THE MODEM CONTROL TOOL Notice: Whenever the driver installation is going to be performed, the modem should be unplugged from the PC!Open the ModemUSB/G10 package, take out the CD and insert it into your CD drive. Click Install in automatically opened window. If the window did not appear, run autorun. exe file located on the CD. The installation procedure of the ModemUSB/G10 modem will begin. Advanced User: Can press Browse button to choose specific folder where you wish to install Modem Control Tool. 1 1 2 2 3 3 2 To continue installation plug in your ModemUSB/G10 now and click OK 5 5 4 4 6 6 i SETTING UP AN INTERNET CONNECTION Using ModemUSB/G10 you can access the Internet via one of the following data transmission types: GPRS packet data transfer. In this case you have to know the APN, User Name and Password (all these parameters would be provided by your GSM operator). You have to know the phone number of a dial-up server (all these parameters would be provided by your GSM operator). In this section we will provide you with general information and procedures necessary for setting up an Internet connection to your PC. If GPRS data transfer is used, you have to set up an APN (Access Point Name), Phone Number, User Name and Password if necessary (all these parameters would be provided by your GSM operator). If you are using CSD, you have to know the phone number of the dial-up server. Setting up an Internet connection to your PC: 1) Start the Modem Control Tool. 3) Enter the APN, User Name and Password (user name and password are not always needed; it depends on your network operator). 5) Click Update after the data was entered. Connecting to the Internet Make sure, that the SIM card is properly inserted into device, the device is properly connected to the PC its , , Power"LED is ON and the drivers are installed properly. [. . . ] Check if the drivers are installed properly. Driver status you can checked in Windows Device Manager, if there will be problems with the Modem or USB Serial Converter, or COM ports, please uninstall the software and try to install it again. If does not help contact your local distributor. 2) 3) Problem: Can't connect to the Internet. Solution: Check if the network parameters are entered correctly. Problem: If Windows/Modem Control Tool cannot find the modem when it is physically connected to different USB port. Solution: If the modem is inserted into a USB port other than the port in which it was inserted previously, please wait until Windows detects the device and installs the drivers automatically. [. . . ]