User manual TENDA W300A

[. . . ] All the photos and product specifications mentioned in this manual are for references only. As the upgrade of software and hardware, there will be changes. And if there are changes, Tenda is not responsible for informing in advance. If you want to know more about our product information, please visit our website at www. tenda. cn. 2 11N Wireless Broadband Router CONTENTS Chapter 1: Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] In the "Wireless settings" menu, click "WPS settings" to enter the next screen. WPS settingsTo enable or disable WPS function. 42 11N Wireless Broadband Router WPS modeProvide two ways: PBC (Push-Button Configuration) and PIN code. PBCSelect the PBC or press the WPS button on the front panel of the device for about one second (Press the button for about one second and WPS indicator will be blinking for 2 minutes, which means the WPS is enabled. During the blinking time, you can enable another device to implement the WPS/PBC negotiation between them. Two minutes later, the WPS indicator will be off, which means the WPS connection is completed. If more clients are added, repeat the above steps. At present, the WPS supports up to 32 clients access. ) PINIf this option is enabled, you need to enter a wireless client's PIN code in the field and keep the same code in the WPS client. WPS Summary Show the current state of Wi-Fi protected setting, including authorized mode, encryption type, default key and other information. WPS Current Status Idle means WPS in idle state. Start MSC process means the process has been started and waits for being connected. Configured means the negotiation is successful between server and clients. You can add or delete them. 46 11N Wireless Broadband Router 6. 7 Connection Status This page shows wireless client's connection status, including MAC address, Channel bandwidth, etc. Select "Wireless Setting->connection status" to enter the following screen: MAC AddressShows current MAC addresses of the hosts connecting to the Router. Bandwidth Shows current bandwidth of the hosts (wireless client). 47 11N Wireless Broadband Router Chapter 7: DHCP Server 7. 1 DHCP Settings DHCP (Dynamic Host Control Protocol) is to assign an IP address to the computers on the LAN/private network. When you enable the DHCP Server, the DHCP Server will allocate automatically an unused IP address from the IP address pool to the requesting computer in premise of activating "Obtain an IP Address Automatically". So specifying the starting and ending address of the IP Address pool is needed. DHCP Server: Activate the checkbox to enable DHCP server. IP Address Start/End: Enter the range of IP address for DHCP server distribution. Lease Time: The length of the IP address lease. For example If the lease time is an hour, then DHCP server will reclaim the IP address in each hour. 48 11N Wireless Broadband Router 7. 2 DHCP List and Binding The Static IP assignment is to add a specifically static IP address to the assigned MAC address. You can view the related information in the DHCP server list. IP Address: Enter the IP address which needs to be bound. MAC Address: Enter the MAC address of the computer you want to assign the above IP address. [. . . ] Run "Ping" command and check if it can ping the Router's LAN IP address 192. 168. 0. 1. If it is OK, please make sure your browser does not access the Internet by proxy server. If the ping fails, you can press the "RESET" 85 11N Wireless Broadband Router button for 7 seconds to restore to default settings. If it still does not work, please contact us. [. . . ]