User manual TERRATEC AXON AIX 103 1.0

[. . . ] TERRATEC PRODUCER/AXON AIX 101/103 English Manual Version 1. 0, status: October 05 CE Declaration We: TerraTec Electronic GmbH, Herrenpfad 38, D-41334 Nettetal, Germany hereby declare that the product: AXON AIX 101 and AXON AIX 103 to which this declaration refers is in compliance with the following standards or standardizing documents: EN 55013(2001)+A1(2003), EN 55020(2002). The following are the stipulated operating and environmental conditions for said compliance: residential, business and commercial environments and small-company environments. This declaration is based on: Test report(s) of the EMC testing laboratory The information in this document is subject to change without notice and shall not be deemed as a warranty by the seller. No warranties, express or implied, are made with regard to the quality, suitability or accuracy of this document. [. . . ] The mounting location must ensure that the length of the pickup cable and the connecting cable to the instrument are sufficient. Neither the controller nor the plug of the connecting cable should extend beyond the edge of the guitar body to reduce the risk of damage. When choosing the mounting location, ensure that the instrument can be placed on a stand with the controller attached. Choose the mounting location to ensure that the instrument will not be subjected to undue pressure while being transported in a bag or case with the AIX 101/103 attached. Selecting the mounting method Mounting with screws and/or adhesive strips/pads Permits the installation of the controller on a curved top in conjunction with adhesive strips Permits simple mounting and secure attachment. Requires a hole to be drilled in the body. Press the controller firmly ­ but carefully ­ into place to ensure proper adhesion. Finally, insert the selftapping button-head screw (3x6 mm) through the hole in the controller and into the hole AXON AIX 101/103 (English) 11 previously drilled in the instrument. Ensure that the screw is only finger-tight. Over tightening the screw can damage the controller or the instrument. Note: The controller can be attached to practically any body type using the adhesive strips or pads. For more information, please see "Reusable adhesive pads" below. Adhesives may react chemically with some instrument finishes, resulting in discoloration or other damage. If in doubt, apply a small piece of adhesive strip/pad in an inconspicuous location for several days to determine whether they affect the finish of the instrument. If your instrument has a curved top or the installation location is shaped in such a way that the controller cannot be attached using adhesive strips alone, apply spacers to compensate for the uneven surface. Like the strips, the spacers also have adhesive on both sides which is protected by backing paper. The adhesive pads can be used in the same way as the strips to attach the controller. The pads can be reused many times, and can be washed carefully with a neutral cleaning product to remove dust and dirt, restoring their adhesive properties. When removing the controller, put the original protective backing back on the pads to keep them in good condition. Cut the Velcro strips, which are attached to one another, into three sections and apply them to the underside of the controller. Cut the Velcro into three sections Underside of the controller 2. Remove the protective backing from the other side of the Velcro strips and attach the controller to the guitar body. [. . . ] Apply one double-sided adhesive strip each to the undersides of the mounting plates. (Do not remove the protective backing. ) 2. Attach the mounting plates to the pickup with screws and springs. Select the correct screw length to ensure the proper height of the pickup (6, 8, 10 or 12 mm). [. . . ]