User manual TEXECOM VERITAS R8

[. . . ] The exit tone and exit timer will resume when all zones are closed. If it is necessary to leave a zone open then it must be omitted (see "To OMIT Zones During Setting" below). If an open zone cannot be closed then it may be `in fault'. If the fault cannot be corrected contact your alarm company. [. . . ] Press " or enter Part Set Suite number # or $ and press %. The system will sound a repeating series of 10 bleeps. The display will illuminate the zones that are about to be armed. The exit tone and exit timer will restart. To RESET During an Alarm Activation To silence the alarm enter your 4 digit code !!!!. The internal and external sounders will stop but the external strobe will continue to flash. The display will flash the zone light of the zone which first caused the alarm activation and illuminate the zone lights of all subsequently opened zones (if any). To cancel the display and stop the external strobe press (. The system will chime and return to unset. 4 INS036-5 To RESET After an Alarm Activation After an alarm activation the internal and external sounders will stop after a pre-set time. The system will re-arm but the external strobe will continue to flash. The system will unset and the entry tone will stop. The display will flash the zone light of the zone which first caused the alarm activation and illuminate the zone lights of all subsequently opened zones (if any). To cancel the display and stop the external strobe press (. The system will chime and return to unset. If the System Requires an Anti-Code After an Alarm Activation The system may be programmed to require an Anti-Code after an alarm activation. You will still be able to silence the alarm by entering your code as normal. However you will not be able to reset the system without first obtaining the Anti-Code. The zone lights will display a random 4 digit sequence. They will flash each digit in turn and then pause before repeating. Contact the phone number on the last page with this sequence in order to obtain a 4 digit Anti-Code which will allow the system to be reset. To display the zone(s) which caused the alarm press (. The zone light of the zone which first caused the alarm activation will flash, and the zone lights of all subsequently opened zones (if any) will illuminate. To return to the random sequence display press ( again. The CHIME Facility When the system is unset it is possible to set one or more zones to Chime. [. . . ] The system will return to unset and all the zone lights will turn off. To Change Your Code Before changing your code, it is vital that you memorise or write down the new code you are about to program. Failure to remember your code will require an engineer visit to re-program a new code for you. Zone lights 1, 2, 3 and 4 will illuminate in turn as each digit of the new code is entered. The system will chime to confirm the new code has been accepted and all the zone lights will illuminate. [. . . ]