User manual THERMADOR 19-10-273L

[. . . ] Before servicing or cleaning unit, such as those published by the National switch power off at service panel and Fire Protection Association (NFPA), the lock the service disconnecting means American Society for Heating, Refrigto prevent power from being switched eration and Air Conditioning Engineers on accidentally. When the service dis- (ASHRAE), and the local code authoriconnecting means cannot be locked, ties. When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities. CAUTION: To reduce risk of fire and to properly exhaust air, be sure to duct air outside. [. . . ] Always use cookware appropriate for the size of the surface element. WARNING: - TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING: A. SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray, then turn off the burner. If the flames do not go out immediately, EVACUATE AND CALL THE FIRE DEPARTMENT. NEVER PICK UP A FLAMING PAN ­ You may be burned. DO NOT USE WATER, including wet dishcloths or towels ­ a violent steam explosion will result. Use an extinguisher ONLY if: 1) You have a Class ABC extinguisher, and you already know how to operate it. 2) The fire is small and contained in the area where it started. 4) You can fight the fire with your back to an exit. PAGE 1 RECOMMENDED FOR USE OVER CONVENTIONAL DOMESTIC GAS AND ELECTRIC RANGES AND COOKTOPS. I FOR USE WITH H/HB/HT HOOD SERIES: FIGURE 1 Longer Bracket (Provided with H/HT Hoods) 7-1/2" 1. 2. Remove the Z-shaped bracket from the VM410 ventilator and discard. Remove the blower mounting bracket from the VM410 and replace with a longer bracket provided with the hood. Insert one end of the blower mounting bracket into the ventilator mounting channel located in the rough-in plate, and slip the other end of the bracket into the well stud (located in the rough-in plate) and tighten it with the flange nut (provided with the hood). Plug the ventilator cord into the receptacle located inside the hood assembly. Hex Nut Attach the transition (3-1/4" x 10") to the top of the rough-in plate, using the two shipping screws. Seal all joints between the rough-in plate and the transition with duct tape. 8" 12-3/4" VM410 3. FIGURE 2 H/HB/HT HOOD SERIES 4. 5. II FOR USE WITH H55/H64/H65 AND VCH3/ VCH8 / VCH9: This ventilator unit designed to be used with Thermador "Designer II" Kitchen Exhaust Hood H55, Thermador "Masterpiece " Kitchen Exhaust H64, H65, Ventilator Control Housings VCH8 or VCH9, Thrustpower II Kitchen Exhaust Hoods, and VCH3 Ventilator Control Housing. Remove hanger rod from ventilator unit (taped to bracket) and attach to inside top of hood housing. Locate hanger rod in correct position for particular ventilator and food combination being installed. [. . . ] Disconnect ventilator plug from hood housing before servicing. For maximum ventilator efficiency, clean filters in hood regularly. Grease should not be allowed to accumulate on hood or ventilator surfaces. Clean lint and grease from ventilator blades at regular intervals. [. . . ]