User manual THOMSON ROC5209

[. . . ] 1 2 3 4 5 6 G : On/Standby or Standby only, depending on the equipment being used. Indicator lamp: The red indicator lights up when any key is pressed. Setup: Allows you to program your remote before the first use. it also allows you to access to secondary functions of certain A/V appliances (Shift). [. . . ] Depending on the format of the transmission codes of the original remote control, your ROC5209 remote control can memorise up to 150 keys. Global delete ­ Delete all the keys copied (this is recommended the first time you use this function) 1. Hold down the SETUP key until the red indicator lamp remains lit. The red indicator lamp goes out and then relights. The red indicator lamp goes out after several seconds. The batteries in the 2 remote controls must be in good condition; change them if necessary. First copy 2 or 3 keys from the original remote control in order to check the compatibility of the codes of both remote controls. Then carry out a global delete of these keys before starting the full learning procedure. Lay out the original remote control and your ROC5209 end to end so as to align the LED diodes on the 2 remote controls. Where necessary adjust the height of both remote controls so that the LED diodes are properly aligned. Place the remote controls with the infrared diodes on a table so that they point each other at a distance between 15 and 50 mm. Check of the programming: In principle, your set is ready for receiving the remote control commands. Check your remote control for proper functioning by performing the test described on page 2. Method C ­ Programming by means of code retrieval Should none of the codes work, you still have the possibility of retrieving the appropriate code without having to perform any input. Hold down the SETUP key until the red indicator lamp blinks and then remains lit. Press the key that corresponds to the type of equipment you want to control: TV: television set, DVD: DVD player, VCR: Video recorder, SAT/CABLE: satellite receiver, cable, DVBT, ADSL, AUDIO/AUX: audio equipment and any other appliance. Direct the remote control towards the set and try to switch it off by pressing the key G. If the set you want to control switches off, press OK to memorise the code. Should the set not switch off, press key G as many times as required (up to 200 times), until the set switches off. Between two key presses, leave enough time for the key corresponding to the red indicator lamp to light up again (about 1 second). Proceeding this way will enable you to see whether the set responds or not. Check of the programming: In principle, your set is ready for receiving the remote control commands. [. . . ] All the keys copied to a mode will be deleted if a 4 figure code is entered for this mode (and likewise for direct entry of a code, search of a code or make). ) corresponding to the device whose volume will always be controlled by the VOL and H keys. All other mode will now punch-through to your chosen mode for Volume and Mute control. adjustment of the volume controls for EACH mode. [. . . ]