User manual THOMSON TH PRIMO 45 FULL

[. . . ] To avoid any risk of damage to the appliance, transport it in its operating position and with its packing blocks in place (depending on the model). While unpacking the appliance, and to avoid the risk of suffocation or physical injury, keep the packaging materials out of the reach of children. To avoid any risk to fixtures and fittings, risk of structural damage or of physical injury etc. , any installation work, connections (to water, gas, electricity and air extraction depending on the model), setting up and maintenance of your appliance must be carried out by a qualified service technician. Your appliance has been designed for use by adults. [. . . ] Do not use more than the correct quantity of detergent to save an environment. Do these steps to fill the detergent dispenser: 1. Open the lid of the detergent dispenser. 12 electrolux 4. If you use detergent tablets, put the detergent tablet in the detergent dispenser (A). 2. Fill the detergent dispenser (A) with detergent. The marking shows the dosage: 20 = approximately 20 g of detergent 30 = approximately 30 g of detergent. If you use a washing programme with prewash phase, put more detergent in the prewash detergent compartment (B). 5. Close the lid of the detergent dispenser. Press the lid until it locks into position. Different brands of detergent dissolve in different times. Some detergent tablets do not have the best cleaning results during short washing programmes. ­ The indicator light for function button B continues to flash. ­ The digital display shows the setting. Rinse aid dispenser deactivated Rinse aid dispenser activated 6. ­ The digital display shows the new setting. Switch off the appliance to save the operation. Fill the salt container and rinse aid dispenser. Adjust the water hardness setting to the highest level. Adjust the water softener to the water hardness in your area. Adjust the rinse aid dosage. Setting and starting a washing programme Set the washing programme with the door ajar. The washing programme only starts after you close the door. Until then it is possible to modify the settings. Do these steps to set and start a washing programme: 1. [. . . ] Connect the water drain hose to the sink spigot and attach it under the work surface. This prevents that the waste water from the sink goes back into the appliance. Connect the water drain hose to a stand pipe with vent-hole (minimum internal diameter 4 cm). max 85 cm Make sure that the drain hose is not bent or squashed to prevent that the water drains does not drain correctly. Remove the sink plug when the appliance drains the water to prevent that the water goes back into the appliance. [. . . ]