User manual THUNDER TIGER 2CH 8217

[. . . ] No part or parts will be sent under warranty without proof of purchase. To receive part or parts under warranty, the service center must receive a proof of purchase and/or the defective part or parts. Should you find a defective or missing part, contact the authorized Thunder Tiger Service/Distributor nearest you. Under no circumstances can a dealer or distributor accept return of a kit if assembly has started. INTRODUCTION Thank you for the purchase of this Thunder Tiger product. [. . . ] trims steering, and the TH trims throttle/brake). On a stick transmitter, the trim levers are located accordingly around the sticks. For more details, please check the transmitter instruction manual. 4 8a OPERATING RADIO STEERING FUNCTION b c a. c. Check the radio steering functions. With the radio transmitter and receiver on, turn the steering wheel/stick to the left. The front tires/wheels should turn left accordingly. If not, flip the steering servo reverse switch. Return the steering wheel/stick to neutral. The front tires/wheels should point straight forward. If not, use the steering trim lever to correct it. Turn the steering wheel/stick to the right. If the vehicle will be operated in an area with fine dust, use filter oil or caster oil instead of fuel. It is important that the foam is only moist to trap dirt and allow air passage. With the foam too wet, limited air can pass through; therefore, limiting engine performance. Finally, make sure the air cleaner boot is securely fastened with a zip-tie. c. 6 12 a a. c. FUELLING b c Remove the cap from fuel bottle nozzle. Squeeze the fuel bottle, insert into fuel, and draw fuel into the fuel bottle. The fuel used should be methanol based model engine glow fuel (available at hobby shops) with 10% to 20% nitro content and 5% to 18% caster/synthetic oil content for lubrication. Fill car's fuel tank with glow fuel. 13 a PREPARING THE ENGINE b c d e f a. b. To start an engine, first remove the glow plug. Check the glow plug by plugging it into the glow plug igniter. The glow plug element should light up brightly. [. . . ] Beware of making equal(but opposite)adjustments to each tie rod. b. c. 8 16 ENGINE BREAK-IN For a new engine (break-in setting), the high speed needle needs to be set as rich as possible. Turn the high speed needle 1/4 turn counterclockwise from initial setting (2. 5 turns from fully closed). Keep doing this until the engine stalls at full throttle, then turn the high speed needle 1/4 turn clockwise. [. . . ]