User manual THUNDER TIGER KATANA ASSEMBLY

[. . . ] Do not touch any part of model that rotates. Check your radio frequency with the proper operating frequency of the area or country. Always check if there are any modelers operating on the same frequency as you are. Also, check your radio for proper operation before operating a model. [. . . ] Run the wire of the speed control through the battery slot area. Cut a piece of double side tape, remove the paper from one side, and attach it to the bottom of your receiver. d. Slip the receiver wire through the built-in chassis antenna mount. Remove the paper from the other side and attach to the chassis as shown. e. Plug the small BEC plug into the receiver's on/off switch. Follow the instructions that accompany your radio receiver system. Use a small zip tie to organize the excess wiring. 3 PREPARING THE RADIO a b c a. c. Install the antenna into transmitter. Check the frequency printed on the transmitter crystal. Check the frequency printed on the receiver crystal, and make sure it matches with the transmitter crystal. Make sure no one will operate on the same frequency when you are. When there is a radio glitch, it will most likely be caused by improper crystal, damaged crystal, or people operating on the same frequency. 4 INSTALLING THE BATTERY PACK (Battery products are not included in kit) a b a. f. Make sure the motor is disconnected or ensure some other way that the wheels are free to rotate. Find the supplied tuning wand in the package or a small screwdriver. Hold the set-up button pressed in for at least 3 seconds using the plastic tuning wand supplied. 7 ADJUSTING ELECTRIC SPEED CONTROL (ESC) (Picture shows the Ace R/C "Veloci-RS" electric speed control pre-installing on PHOENIX Ready-To-Run version). Before operating your model, you have to set to either NEUTRAL, HIGH SPEED and BRAKE position of the electric speed control prior running the motor. g GREEN / RED h i GREEN j k l RED m n o GREEN / RED g. The set-up LED now flashes RED/GREEN to indicate that the ESC is in the set-up mode. Leave the throttle stick at the neutral position and the throttle trim knob/lever in the middle i. Press the set-up button, the neutral setting is now stored, and the set-up LED lightens GREEN. Move the transmitter stick to full-throttle k. Press the set-up button with the stick still in this position l. The full-throttle setting is now stored, and the set-up LED lightens RED. Move the transmitter stick to full brake n. [. . . ] Not enough ventilation to the speed control. 9 BATTERY CHARGING (Battery products and charger are not included in kit) a. Make sure that the battery pack is completely discharged prior to charging. Discharging the battery pack by running the electric motor until it slows down or using a discharger (Not included). b. For best results, let the battery pack cool before charging. [. . . ]