User manual THUNDER TIGER PHOENIX BX RTR PARTS CATALOG

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual THUNDER TIGER PHOENIX BX RTR. We hope that this THUNDER TIGER PHOENIX BX RTR user guide will be useful to you.

Lastmanuals help download the user guide THUNDER TIGER PHOENIX BX RTR.


Mode d'emploi THUNDER TIGER PHOENIX BX RTR
Download
Manual abstract: user guide THUNDER TIGER PHOENIX BX RTRPARTS CATALOG

Detailed instructions for use are in the User's Guide.

[. . . ] 37 2 IMPORTANT SAFETY INSTRUCTIONS READ AND SAVE THESE INSTRUCTIONS Keep these operating instructions in a safe place and pass them on to any future user. Read these Instructions carefully before installing or using the Ventilation System. Use the appliance only for its intended purpose. , WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: ~ a) Use this appliance only in the manner intended by the manufacturer. appliance, switch power off at the service panel and lock the service disconnecting means to prevent power from being switched on accidentally. [. . . ] ^ All external surfaces and controls can be cleaned with a mild solution of warm water and liquid dish soap applied with a soft sponge. Do not use too much water when cleaning the controls. Water could penetrate the electronics and cause damage. 12 Cleaning and Care Special instructions for control buttons The controls may change or become discolored if not cleaned regularly, clean soiled areas immediately. ^ Press the On/Off button on the top of the ventilation system. ^ Press and hold the 0/1 button until the fan turns off. Do not use a stainless steel cleaner on the controls. Grease filters The reusable metal grease filters remove solid particles from the vented kitchen air (grease, dust, etc). This helps keep the ventilation system clean. The grease filters should be cleaned every 3 - 4 weeks, otherwise cleaning will become more difficult. ^ At the upper edge, push the grease filter down until you can pull it forward, then up and out. The installation steps are described in the enclosed "Installation Diagram". Leave these instructions with the appliance for the consumer/user. Information is subject to change. Please refer to our website to obtain the most current product specification, technical & warranty information. 18 Caring for the environment Disposal of packing material The cardboard box and packing materials protect the appliance during shipping. The front panel of the drawer could also be installed to permanently cover the drawer cut-out. 23 Appliance dimensions Installation using the DAG 500 internal blower DAG 500 mounted in front of the exhaust system. DAG 500 mounted behind the exhaust system. Note that the blower must be accessible to install the venting ductwork. 24 Appliance dimensions Installation using the DAG 1000 external blower connection plate Exhaust air ducting to the front. Exhaust air ducting to the rear. Note that the back must be accessible for the installation of the vent duct. 25 Installation The ventilation system is installed directly behind the cooktop. For easiest installation, install the ventilation system first, then the cooktop. The ventilation system must not be installed in an area where there are strong drafts, for instance near windows, doors, etc. Before installation, please read the "Appliance dimensions" and "Important safety instructions". Installation preparation ^ Remove the side screws at the top of the housing, put the top mounting brackets in place and screw them into place. ^ Screw the bottom mounting brackets to the side of the housing using 2 screws each. The brackets are different for the right and the left side. Attach them with mounting clip "A" pointing up. ^ Remove the connection plate from the front of the appliance. ^ Alternatively the bracket can be attached to the front of the appliance. Use the housing screws which were initially removed. 26 Installation Alternatively, or additionally, the appliance can also be attached underneath the countertop with the angle brackets provided. [. . . ] where temperature variations exist, it may need to be insulated to reduce condensation. Only for Canada with the DAG 500 Internal blower: If the installation should meet the construction standard "R2000", then installing the enclosed Reducing Collar is required. It reduces the air flow to a maximum of 300 cfm. In some cases, a condensate trap may also be required to collect and evaporate any condensate which may occur. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE THUNDER TIGER PHOENIX BX RTR

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual THUNDER TIGER PHOENIX BX RTR will begin.

Search for a user manual

 

Copyright © 2015 - LastManuals - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.

flag