User manual THUNDER TIGER PHOENIX ST BX

[. . . ] Children's operating under the supervision of the adults is necessary. Do not operate model products in rain, on public roads, near crowds, near airport, or near areas with restricted radio operation. This product, its parts, and its construction tools can be harmful to your health. Always exercise extreme caution when assembling and/or operating this product. [. . . ] c. Install 8 AA-size alkaline batteries into transmitter. Install the power pack (Flat type battery pack shown in the picture) and connect to the ESC. Caution: Check all the wiring and connections before you connect the speed control to a drive battery. Incorrect polarity will wreck your speed control. 5 RADIO OPERATION a b c a. c. When turning radio on, first turn on the transmitter. When turning off, first turn the receiver off, then the transmitter off. To reverse the functions of servos, use the small, white servo reverse switches located on side of the pistol transmitter (or the inset servo reverse switches located at the bottom of the stick transmitter). To trim the servos on pistol transmitter, use the trim switches on side of the steering wheel (the ST. trims steering, and the TH trims throttle/brake). On a stick transmitter, the trim levers are located accordingly around the sticks. Do not run flat the battery of your transmitter in case of losing control of the car. For more details, please check the transmitter instruction manual. d. e. 6 OPERATING RADIO STEERING FUNCTION a b c a. c. Check the radio steering functions. With the radio transmitter and receiver on, turn the steering wheel/stick to the left. The front tires/wheels should turn left accordingly. If not, flip the steering servo reverse switch. Return the steering wheel/stick to neutral. The front tires/wheels should point straight forward. If not, use the steering trim lever to correct it. Turn the steering wheel/stick to the right. The front tires/wheels should turn right accordingly. 7 ADJUSTING ELECTRIC SPEED CONTROL (ESC) a b c d e f a. [. . . ] Heat may prevent the battery pack from charging to full capacity and also decreases the performance of the battery. c. Once the battery ready to be charged, first plug the AC quick charger into the outlet of AC power source, and then connect the battery input/output harness to the charger. d. Continued to monitor the battery as it is being charged. As soon as the battery is fully charged, disconnect the battery. [. . . ]