User manual THUNDER TIGER PHOENIX ST FUN KIT PARTS CATALOG

[. . . ] Read these instructions carefully before installing or using the Ventilation System. Use the appliance only for its intended purpose. , WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: ~ a) Use this appliance only in the manner intended by the manufacturer. appliance, switch power off at the service panel and lock the service disconnecting means to prevent power from being switched on accidentally. If the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel. [. . . ] ^ After cooking, and with the fan on, press the Delayed Shut Down button 5 ¢15 ­ ­ once: the fan automatically switches off after 5 minutes (5 ¢ lights up). ­ twice: the fan automatically switches off after 15 minutes (¢15 lights up). If you press the Delayed Shut Down button 5 ¢15 again, the fan will not turn off automatically (5 ¢15 goes out). Overhead lighting I Turning the overhead lighting on The overhead lighting can be turned on and off independently of the fan. ^ Press the light button I briefly to turn on the lighting. The I light button indicator illuminates. The overhead lighting comes on at maximum brightness. Dimming the overhead lighting The brightness of the lighting can be adjusted. ^ While the lighting is turned on, press and hold the light button I. The lighting will dim until the button is released. ^ If the button I is pressed and held down again, the lighting will brighten until the button is released. If the I button is pressed continuously, the lighting will cycle between light and dark. Special instructions for appliances with stainless steel surfaces (not applicable to the controls) Stainless steel surfaces can be cleaned using a non-abrasive stainless steel cleaner. To help prevent resoiling, a conditioner for stainless steel can be applied. Special instructions for appliances with colored casings (Special order) It is very difficult to clean this type of surface without causing minor marks to the surface material. This can become particularly noticeable with darker colors and if there is halogen lighting in the kitchen. 14 Cleaning and Care Stainless steel colored controls These controls may become discolored or damaged if not cleaned regularly. Do not use a stainless steel cleaner on these controls. Grease filter The reusable metal grease filters in the hood remove solid particles from the vented kitchen air (grease, dust, etc) and prevent soiling of the ventilation system. The grease filters should be cleaned every 3 - 4 weeks or when the grease filter indicator lights. Glass edge ^ The glass edge can be cleaned using a household glass cleaner. Avoid using sharp metal scrapers and oven spray. , A dirty filter is a fire hazard! ^ To remove the grease filter pull the locking clip forward, lower the filter down 45°, unhook it at the rear, and take it out. Support the grease filter so that it does not fall and damage the cooktop. 15 Cleaning and Care Cleaning the grease filters ^ By hand: use a scrub brush with a solution of warm water and mild dish soap. Do not use the pure detergent, aggressive all purpose cleaners, oven sprays, abrasive cleaning agents or limescale removers. ^ In a dishwasher: place the filter vertically in the lower basket, making sure that the spray arm is not blocked. In a Miele dishwasher use the "Normal" program. [. . . ] Please read and follow the "IMPORTANT SAFETY INSTRUCTIONS" to reduce the risk of personal injury. Follow all local building codes when installing the hood. Exhaust ducting and connections Use smooth or flexible pipework made from approved non-flammable materials for exhaust ducting. To achieve the most efficient air extraction and quietest noise levels, consider the following: ­ The diameter of the ductwork should not be less than 6" (150 mm). [. . . ]