User manual THUNDER TIGER ST-1 PRO

[. . . ] Read these instructions carefully before installing or using the Ventilation System. Use the appliance only for its intended purpose. , WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: ~ a) Use this appliance only in the manner intended by the manufacturer. appliance, switch power off at the service panel and lock the service disconnecting means to prevent power from being switched on accidentally. If the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel. [. . . ] Direct lighting on ^ To turn on, briefly touch the "n" sensor button. The lighting comes on at maximum brightness. Dimming the lighting The brightness of the lighting can be adjusted. ^ With the lighting on, press and hold the "n" sensor button. The lighting will dim until the button is released. ^ If the button is pressed again, the lighting will brighten until the button is released. If the button is pressed continuously, the light will cycle between bright and dark. Direct lighting off ^ Briefly touch the "n" sensor button to turn off the light. Turning off the fan s ^ Touch the "s" sensor button to turn off the fan. ­ If you typically use very little fat for cooking, an interval of 40 or 50 hours can be selected. To reprogram the timer: ^ Touch the "s" sensor button to turn off the fan. ^ Touch the sensor buttons "5m15" and "l" at the same time. Glass surfaces Glass surfaces can be cleaned using a glass cleaner. 14 Cleaning and care Grease filters The reusable metal grease filters remove solid particles from the vented kitchen air (grease, dust, etc) and help keep the exhaust hood clean. At the latest, clean the grease filter when the "l" sensor button lights up. The grease filters should be cleaned every 3 - 4 weeks or when the grease filter indicator lights. Be sure to support the grease filter so that it does not fall onto the cooktop. , A dirty filter is a fire hazard. To remove the grease filters, first open the canopy. ^ Touch the "s" sensor button to turn on the fan. The fan switches to level "2". ^ Press and hold the "2" sensor button for approx. The canopy remains open. ^ Press slightly upward on the grease filter handle to release it from the lower rail, pivot forward and lower it downward. Cleaning the grease filters ­ By hand: use a scrub brush with a solution of warm water and mild dish soap. Do not use the pure detergent, aggressive all purpose cleaners, oven sprays, abrasive cleaning agents or limescale removers. ­ In a dishwasher: place the filter vertically in the lower basket, making sure that the spray arm is not blocked. [. . . ] Do not attach the plate directly to the ceiling with anchors, toggle bolts, etc. , CAUTION When cutting or drilling into the wall or ceiling, do not damage electrical wiring and other hidden utilities. 26 Installation Protective film The casing is covered with a protective film to prevent scratching during transport. ^ Peel off the film before installing the casing parts. 8 screws 8 x 60 mm with 8 washers to secure the ceiling plate to the ceiling. (S10 wall anchors included in the packaging are not for use in USA/CDN) Installation accessories To avoid risk of hand or other injury, avoid contact with sharp edges during the assembly and installation process. , CAUTION 2 screws M4 x 8 mm for securing the chimney. 8 leveling shims to correct any variance in the ceiling. 1 exhaust nozzle 1 hose clamp to secure the ducting. 27 Air extraction , WARNING Danger of toxic fumes. [. . . ]