User manual TIGEX MT 19F1

[. . . ] When the knob is turned clockwise, the oven light and the top and bottom heating elements will come on 8 you can choose the most suitable temperature for cooking your food from the range of values below (Convection Mode). To select the temperature, match the desired temperature with the fixed reference mark on the control panel. 60 • 80 100 • 120 140 • 160 180 • 200 220 Max 240 The oven will automatically reach the temperature set, and the thermostat, which is controlled by the knob, will keep it constant. Top Heating Element Position c Set the knob to this position and the oven light and top heating element come on. [. . . ] €¢ if you use your oven for an extended period of time, condensation may form. €¢ there is a rubber seal surrounding the oven opening which guarantees its perfect functioning. Check the condition of this seal on a regular basis. If necessary, clean it and avoid using abrasive products or objects to do so. Should it become damaged, please contact your nearest After-sales Service Centre. We recommend you avoid using the oven until it has been repaired. €¢ never line the oven bottom with aluminium foil, as the consequent accumulation of heat could compromise the cooking and even damage the enamel. €¢ clean the glass door using non-abrasive products or sponges and dry it with a soft cloth. How to remove the oven door For a more thorough clean, you can remove the oven door. Proceed as follows: • open the door fully; • lift up and turn the small levers situated on the two hinges; • grip the door on the two external sides, shut it slowly but not completely; • pull the door towards you, pulling it out of its seat; Reassemble the door by following the above procedures backwards. 1 2 3 Replacing the Oven Lamp • Disconnect the oven from the power supply by means of the omnipolar switch used to connect the appliance to the electrical mains; or unplug the appliance if the plug is accessible; • Remove the glass cover of the lamp-holder; • Remove the lamp and replace with a lamp resistant to high temperatures (300°C) with the following characteristics: - Voltage: 230/240 V - Wattage 25W - Type E14 • Replace the glass cover and reconnect the oven to the mains power supply. This will allow you both to obtain excellent results and to save on energy (approximately 10%). Therefore the best results when using the grill modes are obtained by placing the grid on the lower racks (see cooking table) then, to prevent fat and grease from dripping onto the bottom of the oven and smoke from forming, place a dripping-pan on the 1st oven rack from the bottom. 0 Cooking position from bottom 3 3 3 3 3 3 3 3 3 3 3 3 3 3 Temperature (°C) 210 210 210 220 220 220-Max 220 220 220 220 210-230 210-230 210-230 Max Pre-eating time (minuts) 15 15 15 15 15 Cooking time (minuts) 75-80 75-80 75-80 85-90 110-115 95-100 120-125 105-110 100-110 90-95 55-60 60-65 40-45 30-35 30-35 30-35 45-50 50-55 Biscuits 0. 0 3 200 Note: cooking times are approximate and may vary according to personal taste. 15 Safety Is A Good Habit To Get Into To maintain the efficiency and safety of this appliance, we recommend that you do the following: • only call the Service Centres authorised by the manufacturer • always use original spare parts • • • • • When handling the appliance, we recommend you always use the purpose provided handles recessed into the sides of the oven to prevent harming people or damaging the appliance itself. This appliance is designed for non-professional, household use and its functions must not be changed. These instructions are only valid for the countries whose symbols appear on the manual and the serial number plate. The electrical system of this appliance can only be used safely when it is correctly connected to an efficient earthing system in compliance with current safety standards. When the appliance is in use, the heating elements and some parts of the oven door become extremely hot. Make sure you don’t touch them and keep children well away. - Using adapters, multiple sockets and/or extension leads; Attempting to install or repair the appliance without the assistance of qualified personnel. [. . . ] D 18 • • Check that the electrical capacity of the system and sockets will support the maximum power of the appliance, as indicated on the data plate. If you have any doubts, call in a qualified technician. If the socket and appliance plug are not compatible, have the socket replaced with a suitable model by a qualified technician. The latter, in particular, will also have to ensure that the cross section of the socket cables are suitable for the power absorbed by the ap- pliance. [. . . ]