User manual TISSOT SILEN-T

[. . . ] on the appropriate one of the relief figures arranged around bezel (4). Sense 3 very short vibrations following by longer vibrations corresponding to the number of minutes you wish to add using the relief figures on the bezel. The minute hand then positions itself over the chosen time. ­ Confirm the setting and restart the Silen-T by pressing the button (3) at the time signal from a reference clock. [. . . ] ­ Place your finger on the 12 o'clock area. After 2 seconds, 2 vibrations indicate that the alarm has been activated. After holding your finger against the touch-sensitive crystal for more than 5 seconds, the alarm test is activated. ­ To deactivate the alarm, press button (3) and hold it down for less than 2 seconds. Place your finger on the 6 o'clock area. After 2 seconds, a single vibration informs you that the alarm has been deactivated. Alarm signal and stop functions ­ Alarm signal function : a series of 7 intermittent vibrations, repeated after 1 minute. ­ Alarm stop function : press the button (3). Note : The alarm does not remain active automatically. Instead, you need to activate it each time you wish to use it. use Reading the time ­ Activate the touch-sensitive crystal by pressing the button briefly (for less than 2 seconds) (3). ­ With your finger, run clockwise across the touch-sensitive crystal (5) at the same time as the internal edge of the bezel (4) which features the reference points in relief. ­ Sense the vibrations, with one continuous vibration for one hour, and one or more intermittent vibrations for the minutes and tell the time by touching the indicator in relief which corresponds to the bezel (4). Examples : ­ 11 hours, 7 minutes = 1 continuous vibration at 11 o'clock and 2 short intermittent vibrations at 1 o'clock. ­ 5 hours 40 minutes = 1 continuous vibration at 5 o'clock and 1 succession of short vibrations at 8 o'clock. Whenever the 2 hands are superimposed, e. g. at 04:22, you receive one continuous vibration at 4 o'clock interposed by 2 short vibrations. Note : It is possible to read the minutes before the hours. w w w. ch 2/3 137_EN / 08. 06 Silen-T * Synchronization This operation can only be performed visually, and it enables you to synchronize the hands to the vibration signals. To do this : ­ Press the button (3) for more than 2 seconds. ­ By holding your finger down on the button (3), sense a second vibration after 10 seconds. [. . . ] Replacing the batteries When your batteries are approaching the end of their useful service life, this is signalled to you with two vibrations each time you handle the watch. The first of these is short, and the second is longer (E. O. L. The 2 batteries need to be replaced simultaneously without delay by either a retailer or an official TISSOT ® agent. Type : Renata 350, 1, 55 V, Ø 11, 60 mm, h. [. . . ]