User manual TJERNLUND 950-0014 RELAY-TIMER KIT NON-ADJUSTABLE 8504067 REV. 1097

[. . . ] 10/97 TJERNLUND PRODUCTS, INC. 1601 Ninth Street · White Bear Lake, MN 55110-6794 PHONE (800) 255-4208 · (651) 426-2993 · FAX (651) 426-9547 Visit our web site · www. tjernlund. com RELAY/TIMER PART NUMBER 950-0014 24/24 VAC NON-ADJUSTABLE RELAY/TIMER OWNERS INSTRUCTIONS THESE INSTRUCTIONS MUST REMAIN WITH EQUIPMENT DO NOT DESTROY ALWAYS FOLLOW HEATER MANUFACTURER'S INSTRUCTION FOR PROPER OPERATION OF HEATER AND RELIGHTING OF PILOT READ INSTRUCTIONS CAREFULLY PART #950-0014 INSTALLATION INSTRUCTIONS 24/24 VAC INPUT APPROX. 45 SECOND NON-ADJUSTABLE POST-PURGE RELAY/TIMER A) Disconnect 115 VAC Power from the Power Venter before continuing. B) All wiring from the Power Venter to the appliance must be appropriate class 1 wiring as follows: installed in rigid-metal conduit, intermediate metal conduit, rigid non-metallic conduit, electrical metallic tubing, Type MI Cable, Type MC Cable or be otherwise suitably protected from physical damage. [. . . ] The control inputs are non-polarity sensitive, meaning that it does not matter which terminal receives the 24 VAC "hot" and which terminal receives the 24 VAC "com". The output or motor switching side of the #950-0014 has three terminals. Viewing the Relay/Timer as depicted in diagram "A", L1 or the 115 VAC "hot" power lead is attached to terminal L1. White or the 115 VAC neutral/return lead is attached to terminal L2 and the Black or 115 VAC "hot" motor lead is attached to terminal M-LOAD. NOTE: In order for the timer to operate after appliance shutdown, terminals L1 and L2 must be powered continuously with 115 VAC. ELECTRICAL RATING The M-LOAD and L2 115 VAC contacts are rated for 1/4 H. P. REPLACEMENT WIRING CONNECTIONS NOTE: When power is first established to the Relay/Timer, it may automatically reset into post purge. After the venter operates for approximately 45 seconds it will shut off and be ready for normal operation. If you are replacing the Relay/Timer of a VP-2 or VP-3, connect the control input voltage as shown in diagram "A". If you are replacing the Relay/Timer of any GPAK-JT/GPAK-1T/GPAK-1TR connect the control input voltage as shown in diagram "B". After new Relay/Timer is installed, run appliance and power vent system through a couple of heating cycles to verify proper operation. If you have any questions regarding installation, please contact our Customer Service Department by calling: 1-800-255-4208, Monday-Friday, 7:30-4:30 CST. TJERNLUND LIMITED ONE YEAR WARRANTY Tjernlund Products, Inc. warrants to the original purchaser of this product that the product will be free from defects due to faulty material or workmanship for a period of (1) year from the date of original purchase or delivery to the original purchaser, whichever is earlier. Remedies under this warranty are limited to repairing or replacing, at our option, any product which shall, within the above stated warranty period, be returned to Tjernlund Products, Inc. at the address listed below, postage prepaid. THERE ARE NO WARRANTIES WHICH EXTEND BEYOND THE DESCRIPTION ON THE FACE HEREOF, AND TJERNLUND PRODUCTS, INC. [. . . ] Send all inquiries regarding warranty work to Tjernlund Products, Inc. 1601 9th Street, White Bear Lake, MN 55110-6794. Phone (651) 426-2993 · (800) 255-4208 · Fax (651) 426-9547. [. . . ]