User manual TJERNLUND 950-0015 SS2 MOTOR KIT 8504069 REV. 0598

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual TJERNLUND 950-0015 SS2 MOTOR KIT 8504069 REV. 0598. We hope that this TJERNLUND 950-0015 SS2 MOTOR KIT 8504069 REV. 0598 user guide will be useful to you.

Lastmanuals help download the user guide TJERNLUND 950-0015 SS2 MOTOR KIT 8504069 REV. 0598.

Mode d'emploi TJERNLUND 950-0015 SS2 MOTOR KIT 8504069 REV. 0598

Download

Manual abstract: user guide TJERNLUND 950-0015 SS2 MOTOR KIT 8504069 REV. 0598

Detailed instructions for use are in the User's Guide.

 [. . . ] TJERNLUND PRODUCTS,  INC. 
1601 Ninth Street · White Bear Lake,  MN 55110-6794 PHONE (800) 255-4208 · (651) 426-2993 · FAX (651) 426-9547 Visit our web site · www. tjernlund. com

SS2 REPLACEMENT MOTOR KIT INSTRUCTIONS

Disconnect power supply before making wiring connections to prevent electrical shock and equipment damage. 

1. Disconnect and label all supply and control voltage electrical connections to SS2 electrical box. Cut the crimp nuts which which contain the Black and White motor leads in SS2 electrical box.  [. . . ] Remove (6) nuts that hold venter housing to the heat shield. NOTE: Save nuts,  spacers,  and wire routing clips for reassembly. Rotate venter housing so motor mounting nuts are accessible,  (See Diagram D). NOTE: Be careful not to bend draft adjustment linkage. Loosen and remove (4) nuts holding motor to heat shield. NOTE: Save nuts and spacers for reassembly. Pull motor wires out of electrical box and remove motor from housing. Install new motor with (4) nuts removed in step 9 and fish motor leads through SS2 electrical box. Make sure spacers are on venter housing. Hand tighten (6) nuts which hold venter housing to heat shield. Insert alignment tool over the motor shaft through venter housing and heat shield,  (See Diagram E). Firmly tighten (6) nuts which hold venter housing to heat shield and remove alignment tool. Replace (2) nuts which hold wire routing clips for limit and motor leads. Slide venter assembly into vent cabinet and reinstall (9) screws.  [. . . ] Run SS2 & appliance through a couple of heating cycles to verify proper operation. 5/98

Copyright © 1998,  Tjernlund Products,  Inc. All rights reserved. 

P/N 8504069

DIAGRAM C

DIAGRAM D

DIAGRAM E [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE TJERNLUND 950-0015 SS2 MOTOR KIT 8504069 REV. 0598

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual TJERNLUND 950-0015 SS2 MOTOR KIT 8504069 REV. 0598 will begin.