User manual TJERNLUND 950-0019 SS2 VENTER HOUSING KIT 8504072 REV. 0598

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual TJERNLUND 950-0019 SS2 VENTER HOUSING KIT 8504072 REV. 0598. We hope that this TJERNLUND 950-0019 SS2 VENTER HOUSING KIT 8504072 REV. 0598 user guide will be useful to you.

Lastmanuals help download the user guide TJERNLUND 950-0019 SS2 VENTER HOUSING KIT 8504072 REV. 0598.

Mode d'emploi TJERNLUND 950-0019 SS2 VENTER HOUSING KIT 8504072 REV. 0598

Download

Manual abstract: user guide TJERNLUND 950-0019 SS2 VENTER HOUSING KIT 8504072 REV. 0598

Detailed instructions for use are in the User's Guide.

 [. . . ] TJERNLUND PRODUCTS,  INC. 
1601 Ninth Street · White Bear Lake,  MN 55110-6794 PHONE (800) 255-4208 · (651) 426-2993 · FAX (651) 426-9547 Visit our web site · www. tjernlund. com

MODEL SS2 REPLACEMENT VENTER HOUSING INSTRUCTIONS

Disconnect power supply before making wiring connections to prevent electrical shock and equipment damage. 

1. Disconnect and label all supply and control voltage electrical connections to SS2 electrical box. Remove vent pipe and SS2 inlet pipe by twisting counter clockwise,  (See Diagram A).  [. . . ] Remove (2) nuts for limit and motor wire routing clips. Remove (6) nuts that hold housing to the heat shield. NOTE: Save nuts,  spacers,  and wire routing clips for reassembly. Carefully remove venter housing from heat shield,  (See Diagram G). Insert damper rod through heat shield and attach venter housing to heat shield by hand tightening (6) nuts. Insert alignment tool over the motor shaft through venter housing and heat shield,  (See Diagram F). Firmly tighten (6) nuts which hold venter housing to heat shield and remove alignment tool. Replace (2) nuts which hold wire routing clips for limit and motor leads. Screw damper rod extension onto damper rod. NOTE: Do not overtighten,  (See Diagram E). Insert pivot pin through pivot pin hole. Install provided retaining clip onto pivot pin using a small nut runner to push retaining clip on. NOTE: The concave "bowl" side of the retaining clip must be facing damper rod extension,  (See Diagram D). Verify that damper adjustment knob rotates freely.  [. . . ] Refer to SS2 Draft Adjustment Procedure in SS2 instruction manual for detailed information. Run SS2 & appliance through a couple of heating cycles to verify proper operation. 5/98

Copyright © 1998,  Tjernlund Products,  Inc.  [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE TJERNLUND 950-0019 SS2 VENTER HOUSING KIT 8504072 REV. 0598

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual TJERNLUND 950-0019 SS2 VENTER HOUSING KIT 8504072 REV. 0598 will begin.