User manual TJERNLUND 950-1067 RELAY-TIMER KIT 8504053 REV 4 0996

[. . . ] at the address listed below, postage prepaid. THERE ARE NO WARRANTIES WHICH EXTEND BEYOND THE DESCRIPTION ON THE FACE HEREOF, AND TJERNLUND PRODUCTS, INC. EXPRESSLY DISCLAIMS LIABILITY FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING FROM THE USE OF THIS PRODUCT. [. . . ] B) All wiring from the Power Venter/Draft Inducer to the appliance must be appropriate class 1 wiring as follows: installed in rigidmetal conduit, intermediate metal conduit, rigid non-metallic conduit, electrical metallic tubing, Type MI Cable, Type MC Cable or be otherwise suitably protected from physical damage. SECTION A (REPLACEMENT OF DEFECTIVE TIMER) 1. Remove the electrical box cover of the Power Venter. Place the replacement Timer next to the defective Timer located in the Power Venter electrical box. One by one, remove the wires from the defective Timer and connect them to the corresponding number on the replacement Timer. NOTE: Terminals 1 and 2 may be positioned differently on this Timer/Relay than on the Timer/Relay you are replacing. For further details refer to wiring instructions. Remove the defective Timer from the electrical box by removing the nut/screw. Install the replacement Timer in the electrical box and secure it with the nut/screw removed in step 4. Adjust the timer to its desired setting by turning the set screw. This Timer can be adjusted from approximately 1 minute to approximately 10 minutes. (Clockwise minimum, Counter Clockwise maximum). CAUTION: Overturning adjustment screw will damage Timer and void warranty. If the defective Timer failed within the 1 year warranty period, you may return it along with proof of purchase to the Tjernlund Distributor it was originally purchased from for a full refund. Remove the electrical box cover from the Power Venter/Draft Inducer. Secure the Timer to the inside of the electrical box using the nut/screw provided. [. . . ] The Timer/Relay kit is supplied with quick-connect leads for when it is installed as an accessory control. In most cases it will be easier to use the existing wire leads when installing it as a replacement for a defective Timer/Relay. If you are replacing the Timer/Relay of a VP-2, WHK-2 or a VP-3, connect the control input voltage as shown in diagram "A". If you are replacing the Timer/Relay of an HST manufactured before August 1st 1992, or any GPAK-JT/GPAK-1T, connect the control input voltage as shown in diagram "B". NOTE: Terminal 4 of the Timer/Relay is Blue in the GPAK-T Series and Orange in the HST-Series. [. . . ]