User manual TJERNLUND 950-2043 ND-1 POST PURGE BURNER KIT 8504004 REV 0196

[. . . ] TJERNLUND PRODUCTS, INC. 1601 Ninth Street · White Bear Lake, MN 55110-6794 PHONE (800) 255-4208 · (651) 426-2993 · FAX (651) 426-9547 Visit our web site · www. tjernlund. com INSTALLATION INSTRUCTIONS FOR ND-1 (950-2043) POST PURGE BURNER KIT DIAGRAM A Make sure all power is disconnected from the furnace/boiler before attempting to install the ND-1. Failure to do so can cause electrical shock resulting in personal injury or death. INSTALLATION OF OIL SOLENOID VALVE ON A BECKETT BURNER (SEE DIAGRAM A) NOTE: The Solenoid Mounting "U" Bracket, 24" Conduit and fittings are not necessary when mounting on a Becket Burner or burner with knock-out on Cad Cell housing. [. . . ] Insert and start the 2 1/2" sheet metal screws to locate the junction box extension to the existing junction box. Install the R8184G primary control and tighten the 2 1/2" sheet metal screws. DIAGRAM B PLAN VIEW ISOMETRIC VIEW DIAGRAM C Make sure all power is disconnected from the furnace/boiler before attempting to install the ND-1. Failure to do so can cause electrical shock resulting in personal injury or death. INSTALLATION OF OIL SOLENOID VALVE ON NON-BECKETT BURNERS 1. Apply pipe sealant to the Solenoid Elbows, insert and tighten to position necessary for oil tubing. Place the metal "U" Solenoid Bracket around Solenoid Valve. Insert 1/2" Chase Nipple to Solenoid Valve and tighten. Using screws provided, attach Solenoid to appliance wall. If Oil Tubing does not reach pump and burner chamber the installer must provide a means of mounting the Solenoid Bracket on an extension. If mounting on a boiler attach Solenoid to exterior boiler wall with the 3/8" self tapping screws using the larger holes in Bracket, (See Diagram C). If mounting on a furnace install Solenoid on interior wall with the 3/8" self tapping screws using the smaller holes in Bracket, (See Diagram D). from the pump to the Valve and the remaining 8" Tube Assy. from the Valve to the nozzle line paying attention to the direction of flow as shown, (See Diagram E). [. . . ] All wiring from the to the post purge kit must be appropriate Class 1 wiring as follows: installed in rigid metal conduit, intermediate metal conduit, rigid non-metallic conduit, electrical metallic tubing, Type MI Cable, Type MC Cable, or be otherwise suitably protected from physical damage. SIDESHOT® WIRED WITH STANDARD HONEYWELL ST9103 CONTROL & BURNER MOTOR POST PURGE SIDESHOT TERMINAL STRIP FURNACE TERMINAL STRIP THERMOSTAT TERMINAL STRIP HST-SERIES WIRED WITH HONEYWELL ST9103 CONTROL AND BURNER MOTOR POST PURGE KIT SIDESHOT® OR HST-SERIES WIRED WITH BURNER MOTOR POST PURGE KIT SIDESHOT® OR HST-SERIES WIRED WITH PHELON CONTROL AND BURNER MOTOR POST PURGE KIT REPLACEMENT PARTS OIL SOLENOID 115V RELAY REV. 1/96 PART# 950-0690 PART# 950-0695 Copyright © 1995 Tjernlund Products, Inc. [. . . ]