User manual TJERNLUND SANTEK AIR CLEANERS 8504022 REV 1 0195

[. . . ] WARNING: Do not attempt to override this switch. Always turn Power Switch to the "Off" position prior to cleaning or servicing. Never stick objects through inlet or discharge grilles. This can result in personal injury and equipment damage. [. . . ] CAUTION: Do not poke any object between or through the cell plates. If a commercial dish washer is available, simply place dirty collecting cells in dishwasher for a complete wash cycle. Stand Cell upright on dry surface with plates in vertical plane for good drainage. REPLACING A WET CELL IN AIR CLEANER CAN RESULT IN EXCESSIVE ARCING . IONIZING WIRES Inspect Ionizing wires after cell is washed for any dirt build-up. If necessary, wipe wires gently with a rag soaked in Santek Cell Brite cleaning solution and rinse. ALUMINUM PRE FILTERS (MODELS XF, XC, XK) Slide Aluminum Pre-Filter from retaining channel. Wash accumulated particles from the surface in a solution of warm water and Santek Cell Brite. Rinse thoroughly and stand upright to dry. POLYESTER PRE-FILTER (MODEL SL-1200) Remove Pre-Filter from inner side of hinged bottom panel by pulling filter off velcro tabs. Filter (available from Santek Distributor) should be replaced if dirt accumulation has significantly discolored white polyester material. CHARCOAL FILTERS (0PTIONAL WITH MODEL SL-1200) Charcoal filters control odors. Replace charcoal filters when room odor becomes noticeable or approximately every 4 months. Excess dirt may be vacuumed from surface between replacement cycles. UNIT CABINET With the Fan Speed Switch in the "Off" position and collecting cells removed, wipe accumulated dirt from cabinet interior and exterior as necessary. Use a mild soap solution or spray type household cleaner. DO NOT SPRAY CABINET WITH HOSE OR PRESSURE WASHER. RE-INSTALL COMPONENTS Re-install collecting cell(s) and other filters into cabinet using the reverse of disassembly instructions listed above. Collecting cell Ionizing wires must always face direction that dirty air enters unit. Collecting cell must rest securely against copper colored electrical contact attached to inner cabinet. 2 3. Thorougly engage Access Door cam locks (Models XF, XC, XK) or Bottom Panel latches (Model SL-1200). AN UNSECURED ACCESS OR BOTTOM PANEL WILL NOT ENGAGE THE INTERLOCK SAFETY SWITCH AND UNIT WLL NOT OPERATE. MOTOR MAINTENANCE (Models XF & SL) Motors are permanently lubricated and need no oiling. (Models XC & XK) MOTOR MUST BE OILED EVERY 6 MONTHS; TO OIL: 1. [. . . ] at the address listed below, postage prepaid. THERE ARE NO WARRANTIES WHICH EXTEND BEYOND THE DESCRIPTION ON THE FACE HEREOF, AND TJERNLUND PRODUCTS, INC. EXPRESSLY DISCLAIMS LIABILITY FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING FROM THE USE OF THIS PRODUCT. THIS WARRANTY IS IN LIEU OF ALL OTHER EXPRESS WARRANTIES AND NO AGENT IS AUTHORIZED TO ASSUME FOR US ANY LIABILITY ADDITIONAL TO THOSE SET FORTH IN THIS LIMITED WARRANTY. [. . . ]