User manual TJERNLUND VH1-6,8,10 VENT HOODS 8504054 REV B 0900

[. . . ] OWNERS INSTRUCTIONS THESE INSTRUCTIONS MUST REMAIN WITH EQUIPMENT DO NOT DESTROY TJERNLUND PRODUCTS, INC. 1601 Ninth Street · White Bear Lake, MN 55110-6794 PHONE (651) 426-2993 · (800) 255-4208 · FAX (651) 426-9547 Visit our web site · www. tjernlund. com MODEL VH1 SERIES VENT HOODS 6", 8", 10" The VH1-8 and VH1-10 do not have a secondary heat shield. A thimble will have to be added to maintain clearances to combustibles if penetrating a combustible wall with these models. Terminate the vent system so that proper minimum clearances are maintained as cited in the latest edition of the National Fuel Gas Code (NFPA # 54) and the latest edition of NFPA #211, or as follows: Not be less than 7 feet above grade when located adjacent to public walk ways At least 3 feet above any forced air inlet located within 10 feet At least 4 feet below, 4 feet horizontally from or 1 foot above any door, window or gravity air inlet into any building At least 12 inches above grade. · · · · THE MANUFACTURER ALSO RECOMMMENDS: · The vent terminal shall also not be installed closer than 3 feet from the inside corner of an L-shaped structure · Not less than 2 feet from an adjacent building · Flue gases are not directed so as to jeopardize people, overheat combustible structures or enter buildings 2. [. . . ] Slide hood through opening from outside. Fasten the vent hood with provided anchors and screws. Install cover plate and fasten to inside wall with provided anchors and screws. Seal all vent pipe connections between the Power Venter and vent hood with high-temperature silicone sealant or metal tape to prevent flue gas leakage. 2. 4. MAINTENANCE The vent system must be inspected regularly. Screened opening of the vent hood should be free from foreign material and cleaned as necessary. Structural integrity of the vent hood should be maintained so as not to reduce vent discharge opening. Check all vent system connections for leakage and re-seal where needed. If any vent pipe shows signs of deterioration, replace immediately and check new connections for possible leaks. Re-seal with high-temperature silicone sealant or metal tape to prevent flue gas leakage. TJERNLUND LIMITED ONE YEAR WARRANTY Tjernlund Products, Inc. warrants to the original purchaser of this product that the product will be free from defects due to faulty material or workmanship for a period of (1) year from the date of original purchase or delivery to the original purchaser, whichever is earlier. Remedies under this warranty are limited to repairing or replacing, at our option, any product which shall, within the above stated warranty period, be returned to Tjernlund Products, Inc. at the address listed below, postage prepaid. THERE ARE NO WARRANTIES WHICH EXTEND BEYOND THE DESCRIPTION ON THE FACE HEREOF, AND TJERNLUND PRODUCTS, INC. [. . . ] Send all inquiries regarding warranty work to Tjernlund Products, Inc. 1601 9th Street, White Bear Lake, MN 55110-6794. Phone (651) 426-2993 · (800) 255-4208 · Fax (651) 426-9547 or email us at fanmail@tjfans. com. P/N 8504054 ©2000, Tjernlund Products, Inc. REV. [. . . ]