User manual TOMY DUSTBOT

[. . . ] POWER ON Make sure both the Baby and Parent Units are plugged into the mains and/or have their batteries installed (see above). The units should stand at least 1 metre apart. Press and hold the button on each unit for at least 2 seconds. As each unit activates, watch for the Sound Level Lights Display on the Parent Unit as it scrolls from left to right and right to left as the Parent and Baby Units auto-search and link to each other. [. . . ] The louder your baby, the more lights illuminate on the display. You can lower the volume of the Parent Unit whilst still watching out for baby, ideal for when you're relaxing or entertaining. SOUND ACTIVATED MONITORING For those quiet moments or when your baby is a little older you may not want to hear every sound in your baby's room. Your Baby Monitor has a Sound Activated Monitoring mode, a feature that only captures sounds above a preset threshold, for example a cry rather than a gurgle. select Sound Activated Monitoring by pressing the button on the Parent Unit. The Parent Unit will mute 15 seconds after your baby settles. Every time your baby's sounds rise above the threshold this feature will be interrupted instantly and normal sound monitoring will continue until your baby settles again. 2-WAY TALKBACK For that little extra reassurance and convenience, your monitor has a 2-Way Talkback feature that allows you to speak to your baby. Press and hold down the button on the side of the Parent Unit to activate and speak to your baby. ACCESSORIES; TOMY'S MOVEMENT SENSOR PAD MONITOR AND ADDITIONAL PARENT UNITS For extra reassurance Tomy's Movement Sensor Pad Monitor and/or an additional Parent Unit from either the Tomy Digital or Digital Plus models can be added to your Monitor. For further details please visit our website: www. No other adaptors than those supplied should be used with your monitor. Be careful not to position the adaptor where a child is likely to use it as a step. Putting weight on the adaptor while it is plugged in could damage the unit or cause injury to your child. It is normal for chargers to become hot during use ­ take care when handling, allow heat to disperse. Disconnect charger if the product will not be used for several days. To prevent a shock hazard, please disconnect from power supply before cleaning. The rechargeable battery within the Parent Unit should be recycled. Do not attempt to dismantle any part of this product. The rechargeable battery maybe below the Place the Parent Unit on charge and leave for several minutes before switching ON. critical voltage to activate your monitor. Check the power cable connections (including wall socket). [. . . ] Should your monitor not be operating as expected, the information listed below should be adequate to resolve your problems; alternatively a more comprehensive guide can be found on our website: www. Does my Parent Unit need to be switched on or off whilst charging?Either, your Parent Unit will charge whilst switched on or off, however charging the unit whilst switched on will allow you to monitor your baby whilst charging. I have measured the temperature of my baby's room using another device and I get a different reading than that of my monitor- why? [. . . ]