User manual TORNADO TO4413

[. . . ] Disconnect the plug from the electrical outlet before changing the dust bag or dust container. To avoid damage, please remove the plug by grasping the plug itself, not by pulling on the cord. This appliance is not intended for use by young children or infirm persons without supervision unless they are adequately supervised by a responsible person to ensure that they can use the appliance safely. Young children should be supervised to ensure that they do not play with the appliance. [. . . ] The use of an extension cord is not recommended. If your vacuum cleaner is not operating correctly, switch off the power supply and consult an authorized service agent. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. Don't carry the vacuum cleaner by holding the hose. Turn off the power switch before unplugging. Please do not press the button of dust bin handle when carrying machine. When removing the plug from the electrical outlet, grasp the plug, not the cord. NOTE : Don't cover the handle sender when Working, the cleaner can be operated using the ON/OFF button on the body of the machine. RECEIVER The IR light indicates the part that receives the infra-red signal from the handle control. The filter light is illuminated when the dust pack requires checking or emptying. Take the dust bin out by pressing the button. After empting the DUST BIN, remove the obstacles like hair, fur on the cap of the DUST BIN. Before use, push the dust bin into the main body of the vacuum cleaner until you hear the "click" sound. You may rinse the dust bin with cold water - Please, check the dust bin and dust pack if suction is noticeably reduced or the filter check indicator lamp turns on after empting the dust bin. the lamp will illuminate to signal when suction is reduced. If the light comes on, please clean the DUST BIN as shown. Please, check the filter check indicator lamp (4-3) as shown in the following illustrations if the lamp is still illuminated even after cleaning the dust bin. After empting the DUST BIN, remove the obstacles like hair, fur on the cap of the DUST BIN. Turn the vacuum power to 'MAX' If the filter check indicator turns red with the inlet floating 10 cm above flat floor, clean the DUST PACK. Remove the fixed frame of the dust pack cover. [. . . ] Remove the sponge and filter from the dust pack Wash the sponge and the filter of the dust pack with water. Let the sponge and filter dry in the shade for more than 12 hours. Put the sponge and filter into the dust pack. Before reassembly, align the dust pack cover and dust pack correctly. [. . . ]