User manual TORNADO TO4516N

[. . . ] · If vacuum cleaner is not working as it should, or has been dropped, damaged, left outdoors or dropped in water, take it to a service center. · Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull the cord around sharp edges or corners. · Do not unplug by pulling on the cord. To unplug, grasp the plug, not the cord. [. . . ] Mini Turbo Brush Front Back WARNING! OPERATE THE VACUUM CLEANER ONLY AT THE VOLTAGE SPECIFIED ON THE NAMEPLATE. Step 1. Attaching the Handle 1-2 Stand the vacuum upright and slide the base of the handle firmly into the grooves at the top of the vacuum body. 1-3 Insert the screw provided into the existing hole. Tighten the screw securely with a screwdriver. Before securing the handle, please check that the handle is fitted to the vacuum body and make sure there's no gap. Step 2. Attaching the Hose and Tools Line up the tabs on the 1-4 1-5 base of the Twist Snap Hose with the corresponding notches on the hose collar as shown. Slide the end of the hose wand with tabs into the Hose Wand Base. 1-6 Slide the extension wand and the crevice tool together into the storage clip. 1-7 Attach the Mini Turbo Brush by putting the rib at the bottom of Mini Turbo Brush on two hooks of Handle. Snap Mini Turbo Brush into place as shown. 2 Operation 2-1 2-2 2-3 ON-OFF Switch 1. To turn cleaner on, press the Power switch. 2. To the cleaner off, press the Power switch again. Handle positions The handle of your cleaner has three positions; upright for storage and when using cleaning tools; operating for general operation on carpet and floors; low for reaching under low furniture. Step on handle release pedal to lower handle. Transporting cleaner To move your cleaner from room to room, put the handle in upright position, tilt the cleaner back on its rear wheels and push forward. 2-4 2-5 A B C Carrying handle The cleaner can also be moved by using the carrying handle. D option E Cleaning Tool attachments Attachment tools can be used to clean furniture or drapes, on stairs or in corners. When using the attachments, ensure the vacuum cleaner is placed firmly on the floor with the handle in the upright position. Do not place the vacuum on top of furniture or steps as the brushroller may cause damage. A. It is located underneath the Dirt Cup and Filter Cup in the Center of the round part of the Cyclone-Lever. Remove the small round Filter and any debris on top of it. Rinse well under warm water, then air dry thoroughly before replacing. The Post-Motor Filter assists in the filtration process to return clean air to the room. It is located behind the door on the front of the Cleaner. When the filter becomes dirty, The Hepa-Filter : Open the door, remove the filter and replace. The Hepa-Filter is not washable and must be replaced. Replace the door by inserting the tabs on the left side and snapping the right side into place. Grasp the Circular Filters and twist to unlock. Separate the Outer foam and Inner pleated Circular Filters. Wash each individually by hand in warm water. Rinse well, then air dry Thoroughly dry before putting them back together and replacing in the Filter Cup The Filter Cup may be washed In warm water with a mild detergent. Make sure it is completely dry before reassembling with fliters. [. . . ] If the Grille was blocked, check and clear the grille in the center of the Cyclone. Remove the Hose and disconnect the Wand. Check for clogs in the vacuum base, the wand, the hose and the suction inlet. If the blockage persists, turn the vacuum cleaner off and unplug it. Lift up the short hose in the base of the vacuum. Inspect the hose for clogs and remove any obstructions. [. . . ]