Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual TORO 22 RECYCLER. We hope that this TORO 22 RECYCLER user guide will be useful to you.
Lastmanuals help download the user guide TORO 22 RECYCLER.
Detailed instructions for use are in the User's Guide.
[. . . ] 220000001 and Up
Operator's Manual
Introduction
Read this manual carefully to learn how to operate and maintain your product properly and to avoid injury and product damage. You are responsible for operating the product properly and safely. Whenever you need service, genuine Toro parts, or additional information, contact an Authorized Service Dealer or Toro Customer Service and have the model and serial numbers of your product ready. The illustration below identifies the location of the model and serial numbers on the product. [. . . ] Remove the dipstick, wipe it clean, and fully install the dipstick.
m-5571
m-5653
m-5570
m-5653
2. Remove the dipstick and check the oil level. If the oil level is below the Add mark on the dipstick, slowly pour oil into the oil fill tube to raise the oil level to the Full mark on the dipstick. fill: 20 oz. , type: SAE 30 detergent oil with an API service classification of SF, SG, SH, or SJ. ) 3. Install the dipstick.
3328-280
6
Adjusting the Cutting Height
Adjust the cutting height as desired. Set all four wheels to the same height.
1-1/4, 1-5/8, 2-3/4,
2,
3-1/2, 4-1/4, 3-7/8,
2-3/8, 3-1/8,
m-5629
FRONT
m-5605a
m-5653
Adjusting the Handle Height
To adjust the handle height, squeeze the bottom of the handle halves together (as shown) and change the handle holes in which the pins (A) are mounted, as follows: · · Raise the handle using hole (B). Lower the handle using hole (C).
B A C
m-5614
m-5612
Installing/Removing the Grass Bag
1. Install the bag over the door rod.
m-5654
2. Remove the rear discharge plug.
m-5587
m-5655
4. To remove the bag, reverse the steps above.
Warning
To avoid personal injury, never recycle the grass without the rear discharge plug in place.
3328-280
7
Installing/Removing the Side Discharge Chute
1. Lift up the lock on the side discharge door.
Operation
Starting the Engine
1. Firmly push in the primer 3 times with your thumb, holding the primer in for a second before releasing it each time. Note: If the air temperature is below 55°F (13°C), firmly push the primer in 5 times. Hold the blade control bar (A) against the handle.
m-5572
m-5583
2. Lift open the side discharge door.
m-5584
3. Install the side discharge chute and close the door onto the chute.
A
m-5644
3. Start the engine using the recoil starter.
m-5585
4. To remove the side discharge chute, reverse the steps above. Important: Push down on the lock after you close the side discharge door.
m-5645
4. Avoid striking solid objects with the blade. If the mower strikes an object or starts to vibrate, immediately stop the engine, disconnect the wire from the spark plug, and examine the mower for damage. For best performance, install a new blade before the cutting season begins.
·
After cutting the lawn, ensure that half of the lawn shows through the cut leaf cover. [. . . ] Install the spark plug and tighten it with a torque wrench to 15 ft-lb (20 Nm). Connect the wire to the spark plug.
3328-280
13
3328-280
14
3328-280
15
3328-280
The Toro Total Coverage Guarantee and The Toro Starting Guarantee on GTS-2 (Guaranteed to Start) Engines
A Full Two-Year Warranty (Limited Warranty for Commercial Use)
Conditions and Products Covered under The Toro Total Coverage Guarantee
The Toro Company and its affiliate, Toro Warranty Company, promise to repair any Toro Product used for residential purposes* if defective in materials or workmanship or if it stops functioning due to the failure of a component. The following time periods apply from the date of purchase: Products · · Recyclerr Walk Mowers Batteries Warranty Period 2 year full warranty 1 year full warranty
This warranty covers the cost of parts and labor, but you must pay transportation costs. This warranty applies to all steel deck Toro Recycler Walk Mowers.
Conditions and Products Covered under The Toro Starting Guarantee
The Toro Company and its affiliate, Toro Warranty Company, guarantee that your Toro GTS-2 Engine, when used for residential purposes*, will start on the first or second pull for two years from the date of purchase, if you provide the routine maintenance it requires, or we will fix it free of charge. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE TORO 22 RECYCLER
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual TORO 22 RECYCLER will begin.