User manual TOSHIBA AV-565

[. . . ] Série AV56* DIGITAL Contents INSTALLING YOUR TV Safety Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Installation and important information . . . . . . . . . . . . . . . . . . . . 5 The remote control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Inserting batteries and effective range of the remote . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Sleep Timer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25 Digital on-screen information and Programme Guide . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26 Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26 Guide . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] When the set powers back on, the Quick Setup screen will appear. Press Q to continue, the television will then auto tune. (See `Quick Setup' section on page 11. ) 31 CONTROLS AND FEATURES Input selection and AV connections See page 7 for a clear view of the back connection recommendations. Most media recorders and decoders send a signal through the SCART lead to switch the television to the correct Input socket. Alternatively press the external source selection button o until the picture from connected equipment is shown. This button must be used to view equipment connected using the COMPONENT VIDEO INPUT (EXT3) and the VIDEO INPUT (EXT4). An S in the display e. g. o2S (EXT 2S), indicates the input is set for an S-Video signal. INPUT signal selection This specifies the type of signal going into SCART 2 (EXT2) on the back of the television. Please refer to the manufacturer's instructions for the connected equipment. a In the SETUP menu press u until AV Connection is highlighted, then press Q. SETUP Menu Language Country Auto Tuning ATV Manual Tuning DTV Manual Tuning DTV Settings AV Connection Picture Position English France English Input selection Use the Input Selection window if the television does not switch over automatically. a b At any time by pressing o a list will appear on screen showing all inputs and external equipment. Use U and u to highlight an input and Q to select. Inputs DTV 1 2 3 4 HDMI1 HDMI2 ATV With I or i select either AV or S-VIDEO as the required input for EXT2. AV Connection HDMI1 Audio Lip Sync EXT2 Input Digital Output Digital Off AV Auto If video colour is absent, try the alternative setting. HDMITM displays equipment connected to Input HDMI on the back of the television. 32 CONTROLS AND FEATURES HDMI1 Audio If the connected HDMI source does not support digital audio, plug the audio cable into HDMI1 (AUDIO) on the back of the television (as shown in the `Connecting an HDMITM or DVI device to the HDMI input' section), then use the HDMI1 Audio setting. Lip Sync Latency Lip Sync can synchronize the sound and picture. This feature is only available for HDMI equipment compatible with Lip Sync. NOTE: Disconnect the HDMI cable before changing the Lip Sync setting. If the HDMI cable is connected, a message will appear. a In the AV Connection menu press u to highlight HDMI1 Audio and using I or i select Auto or Analogue. AV Connection HDMI1 Audio Lip Sync EXT2 Input Digital Output Auto Off AV PCM a b c Select the appropriate HDMI input from the input selection window. In the AV Connection menu press u to highlight Lip Sync. Using I or i select On or Off. English Digital Output If the sound is missing select an alternative setting. NOTE: HDMI1 supports digital and analogue sound, HDMI2 is digital sound only. Certain DVD disk formats may not output from this TV (32/44. 1/48kHz and 16/20/24 bits are acceptable). When connecting a surround sound amplifier to the digital audio output (Sony/Philips Digital Interface Format [S/PDIF]), the following options can be selected. PCM: this mode outputs PCM format to the digital audio output socket. Auto: this mode outputs Dolby Digital or PCM to the digital audio output socket providing it is being broadcast. Dolby Digital S Dolby Digital Dolby Digital Plus S Dolby Digital MPEG S PCM a b In the AV Connection menu press u to select Digital Output. Use I or i to select PCM or Auto. HDMI, the HDMI logo, and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing, LLC. 33 TEXT SERVICES Text services This television has a multi-page text memory, which takes a few moments to load. It offers two Modes of viewing text ­ Auto will display Fastext, if available. List will store your four favourite pages. Navigating pages using Auto If Fastext is available four coloured titles will appear at the base of the screen. [. . . ] SHOULD THE LIBRARY PROVE DEFECTIVE, YOU ASSUME THE COST OF ALL NECESSARY SERVICING, REPAIR OR CORRECTION. IN NO EVENT UNLESS REQUIRED BY APPLICABLE LAW OR AGREED TO IN WRITING WILL ANY COPYRIGHT HOLDER, OR ANY OTHER PARTY WHO MAY MODIFY AND/OR REDISTRIBUTE THE LIBRARY AS PERMITTED ABOVE, BE LIABLE TO YOU FOR DAMAGES, INCLUDING ANY GENERAL, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE USE OR INABILITY TO USE THE LIBRARY (INCLUDING BUT NOT LIMITED TO LOSS OF DATA OR DATA BEING RENDERED INACCURATE OR LOSSES SUSTAINED BY YOU OR THIRD PARTIES OR A FAILURE OF THE LIBRARY TO OPERATE WITH ANY OTHER SOFTWARE), EVEN IF SUCH HOLDER OR OTHER PARTY HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. END OF TERMS AND CONDITIONS How to Apply These Terms to Your New Libraries If you develop a new library, and you want it be of the greatest possible use to the public, we recommend making it free software that everyone can redistribute and change. You can do so by permitting redistribution under these terms (or, alternatively, under the terms of the ordinary General Public License). [. . . ]