User manual TOSHIBA B-415

[. . . ] TEC Portable Printer B-415 SERIES Owner's Manual Table of Contents Copyright © 2003 by TOSHIBA TEC CORPORATION All Rights Reserved 570 Ohito, Ohito-cho, Tagata-gun, Shizuoka-ken, JAPAN CE Compliance (for EU only) This product complies with the requirements of EMC, Low Voltage and R&TTE Directives including their amendments. FCC Notice This equipment has been tested and found to comply with the limits for a Class B digital device, in accordance to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] (When this LED lights up, printing cannot be performed. ) Flashes for three seconds when the power is turned on to indicate that the battery has reached the end of its life. (Recommended that you should replace the battery with a new one. ) ERROR LED (Red) Blinks when an error has occurred. s s 3. 3 Description of Switch/Button s POWER SWITCH A slide power switch. Full appearance of the orange mark indicates power ON. Fully hidden orange mark indicates power OFF. FEED BUTTON Each time this button is pressed, the printer re-issues the previous label. When the button is held, the printer issues labels continuously. E3-1 s 4. LOADING AND REMOVING THE BATTERY ENGLISH VERSION EO1-33014 4. LOADING AND REMOVING THE BATTERY CAUTION: 1. Be sure to turn off the printer before loading the battery. Failure to do this may cause fire or electric shock. In the United States, used lithium ion batteries should be returned to the store where you bought the machine. LITHIUM ION BATTERY DISPOSE OF PROPERLY Caution: Do not handle a damaged or leaking lithium ion battery. · Battery Performance A fully charged battery can print 200 labels or more. Under the temperature 25°C, it can print 400 to 500 labels. Insert the battery as shown below until it goes no further. Slide the battery cover back while pushing the battery, and fully close the cover until it clicks. To remove the battery, gently tilt the printer while supporting with the hand. NOTE: Care must be taken to tilt the printer. Failure to do this may cause the battery to rush out. Battery Cover Battery Fig. LOADING AND REMOVING THE BATTERY ENGLISH VERSION EO1-33014 4. LOADING AND REMOVING THE BATTERY · TO CHARGE THE BATTERY PACK This printer includes no battery charger. Charging the battery requires an exclusive battery charger. Please order the following one to your authorized TOSHIBA TEC representative if necessary. [. . . ] When one of the following errors is found during the command analysis. · Error of command length · Error of command transmission sequence · Error of command format · Error of parameter designation 2. designated by the data print command has not been entered. (2) Feed Jam (Paper Feeding Error) If the printer fails to detect the gap after feeding a label 1. 5 times as long as the label pitch designated by the label size setting command. [. . . ]