User manual TOSHIBA BMS-CM1280TLE INSTALLATION MANUAL

[. . . ] COMPLIANT MANAGER Installation Manual Model name: BMS-CM1280TLE BMS-CM1280FTLE · Save These Instructions! ENGLISH Compliant Manager Installation Manual Contents 1 PRECAUTIONS FOR SAFETY . 3 2 PACKAGED ITEMS OF COMPLIANT MANAGER . 4 3 INSTALLATION OF THE COMPLIANT MANAGER . 5 4 CONNECTION OF POWER CABLES/SIGNAL WIRES/EARTH WIRES . [. . . ] * The following setting procedure is described based on button operations of the wired remote controller RBCAMT32E or RBC-AMT31E. (1) Press the button and button simultaneously for at least 4 seconds. (Note: Do not press the button during setting. ) (2) Press the button to change the CODE No. (3) Set central control addresses (group numbers) with the buttons. · Group numbers used for the Compliant Manager are central control addresses (DN item 03). · The effective address range is 1 to 64. However, there must be no duplicate address on the same line. · An address value of 99 is used as an unset address. (4) Press the button to fix the setting. (5) Press the button to exit the address setting mode. * This setting procedure may vary depending on the wired remote controller model. * Perform these steps while air conditioners are not working. 13-EN ­ 14 ­ Compliant Manager Installation Manual B Manual setting Set central control addresses (group numbers) manually from the Compliant Manager. (1) Press the button and ZONE button simultaneously for at least 4 seconds. (3) Select the line on which the unit exists and the zone and group in which addresses are to be registered with the LINE button, ZONE and buttons, and GROUP and buttons. · When a zone is selected, group numbers registered in the zone are displayed. · Groups whose numbers are displayed are already registered. · Even when addresses have been registered, the registration can be cancelled with the button. (4) Select the unit to be registered in the group selected in step (3). · Switch refrigeration system No. 1 to 31 with the button, and then switch indoor unit No. 1 to 64 with the button. · When no system exists, indoor unit number is displayed as "- -". · System number 31 is for a local adapter and heat exchange ventilators. An indoor unit number is always displayed regardless of whether the unit exists or not. [. . . ] The set content for registration change is stored in the memory. * After the memory write operation has been completed, the Compliant Manager exits the zone setting mode. ­ 17 ­ 16-EN Compliant Manager Installation Manual 9 NOTE CHANGING RETURN-BACK TIME/ TEMPERATURE SETTINGS Return-back time and return-back temperature (CODE No. settings) can be changed using the following procedure. Do not change the data of CODE No. 0A and the following item codes to prevent the remote controller from malfunctioning. [. . . ]