User manual TOSHIBA BRST-10

[. . . ] TEC Ink Jet Printer BRST-10 SERIES Owner's Manual Table of Contents DECLARATION OF CONFORMITY (for EU only) Manufacturer Address : : TOSHIBA TEC CORPORATION 570 Ohito, Ohito-cho, Tagata-gun, Shizuoka-ken, Japan declares, it sole responsibility, that the product Product Name Model Number : : Remote Printer BRST-10 conforms to the following standards under EMC Directive (89/336/EEC, 93/68/EEC) and Low Voltage Directive (73/23/EEC, 93/68/EEC) : EMC : : LVD : EN55024 EN55022 EN60950 Information technology equipment - Immunity characteristics Limits and method of measurement Limits and methods of measurement of radio disturbance characteristics of information technology equipment Safety of imformation technology equipment, including electrical business equipment WARNING This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures. Dans un environnement domestique, il peut causer des interférences radio. Auquel cas, I'utilisateur sera amené à prendre les mesures adéquates. [. . . ] INSTALLATION PROCEDURE EO1-13013 5. 2 LOADING THE HEAD UNIT/ INK CARTRIDGE 3. Remove the protection pad from the head unit/ ink cartridge. Remove the protection sheet from the head unit/ ink cartridge. Do not touch the area that had been under the protection sheet with your fingers or with any object. To avoid the head unit/ ink cartridge from which the protection sheet has been removed from getting dry, install it into the printer as soon as possible after removing the protection sheet. Do not install the head unit/ ink cartridge with the protection pad and the protection sheet attached. Do not remove the protection sheet while the head unit/ ink cartridge faces down. Also do not drop or shake the head unit/ ink cartridge. Once ink gets on your clothes, it cannot be removed. Protection pad 1 2 Protection Sheet Fig. Load the head unit/ ink cartridge onto the carriage, and then fully push it in the arrow-indicated direction until the hook secures the cartridge. Head Unit/ Ink Cartridge Hook Carriage Fig. INSTALLATION PROCEDURE EO1-13013 5. 3 LOADING THE RECEIPT ROLL 6. The printer performs the initial operation. After the initial operation is finished, the carriage returns to the home position (right end). RESET POWER POWER ERROR INKOUT CARTRIDGE SLIP FEED 7. Insert the two hooks into the holes on the top cover, and then close the printer cover slowly. Printer Cover Hooks Top Cover Fig. Cut off both adhesive areas of a new receipt roll. NOTE: Do not insert the receipt paper with adhesive portions into the printer. If so, adhesive will attach to the feed roller. This may cause a slant print or a paper jam. Adhesive Adhesive Fig. INSTALLATION PROCEDURE EO1-13013 5. 3 LOADING THE RECEIPT ROLL 3. Load the receipt roll into the paper holder as the figure shows. 2 Receipt Roll NOTE: Set the receipt roll in correct direction. Paper Cover Cut the paper end to make it sharp. Fig. Insert the receipt straight into the receipt inlet. [. . . ] Check Point · Is the power cord plugged in correctly?· Is the power supplied to the AC outlet?· If it is not a power failure, check for the power supply to the AC outlet with another electric appliance. When the power is not supplied, contact your nearest power company. [. . . ]