User manual TOSHIBA CF13E23

[. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. [. . . ] As the volume level increases, so do the number of bars. If the volume decreases, the number of green bars also decreases. 3 Set the TV/CATV menu option to the appropriate position (See page 22). TV - VHF/UHF Channels CATV - CABLE TV Channels VOL VOL + VOLUME 32 VHF/UHF/CATV CHANNELS TV VHF 2-13 UHF 14-69 CATV VHF 2-13 STD/HRC/IRC 14-36 (A) (W) 37-59 (AA) (WW) 60-85 (AAA) (ZZZ) 86-94 (86) (94) 95-99 (A-5) (A-1) 100-125 (100) (125) 01 (5A) SL EE P D EN SO OI LT C AP C 1 4 A C M EN U SE T/ TR + 4 2 W PO 7 5 3 IN ER LL P U T 8 6 S K IP S S E LE C T 0 L AG IT IN IG K D AC TR E 9 R TE NT UE O ES CR A L E NN NR AU HT C RE R C H C A N C EL EN TE R M U TE O R RN ZE TU E R O V L RA M PR OG SP C H + /S LP RE W P Y LA TIM RE E CR PA US E/S TIL 1 2 C H O V R EC L + EJ EC T L ST OP FF Press the Direct Channel selection buttons to select the channel. TV mode direct channel selection When the TV/CATV menu option is in the TV position, all channels can be instantly selected by using two buttons (for example, to select channel 2, press "0", then "2". If you press only "2", channel selection will be delayed for a few seconds). For channels 10 and above, press the 2 digits in order. 0 1 2 CATV mode direct channel selection When the TV/CATV menu option is in the CATV position, channels can be selected as follows: TO SELECT CATV CHANNELS: 1-9 Press "0" twice, then 1-9 as needed. Example, to select channel 2, press "002". 10-12 Press "0", then the remaining 2 digits. Example, to select channel 12, press "012". Example, to select channel 36, press "36". CH 012 100-125 Press the 3 digits in order. Closed Captioned text is only displayed in locations where it is available. If the Call display is on, the Closed Captioning text will not appear. 20 WHAT IS CLOSED CAPTIONING?This television has the capability to decode and display Closed Captioned television programs. Closed Captioning will display text on the screen for hearing impaired viewers or it will translate and display text in another language. CLOSED CAPTIONING WITH A VCR Closed Captioned programs can be recorded and played back on a VCR with the Closed Captioned text intact. The Closed Captioned text will disappear during Cue (Fast Forward Search), Review (Rewind Search) and Pause Modes or if the VCR tracking is not adjusted properly. TO VIEW CLOSED CAPTIONS Press the CLOSED CAPTION button on the remote control to switch between normal TV and the two Closed Caption Modes (Captions and Full Screen Text). Captions: This Closed Caption Mode will display text on the screen in English or another language (depending on the setting of the Closed Captions CH. Generally, Closed Captions in English are transmitted on Captions Channel 1 and Closed Captions in other languages are transmitted on Captions Channel 2. Text: The Text Closed Caption Mode will usually fill the screen with a programming schedule or other information. After selecting a Closed Caption Mode, it will stay in effect until it is changed, even if the channel is changed. If the Captions signal is lost due to a commercial or a break in the signal, the Captions will reappear when the signal is received again. [. . . ] You pay for all transportation and insurance charges for the set to and from the Service Station. Limited One (1) Year Warranty TACP/THI further warrant the parts in this product against defects in materials or workmanship for a period of one year after the date of original retail purchase. During this period TACP/THI will replace a defective part without charge to you, except that if a defective part is replaced after ninety (90) days from the date of original retail purchase you pay labor charges involved in the replacement. You must also deliver the entire product to a TACP/THI Authorized Service Station. You are responsible for all transportation for the set to and from the Service Station. Limited Two (2) Year Warranty of Picture Tube TACP and THI further warrant the picture tube in this product against defects in materials or workmanship for a period of two (2) years after the date of original retail purchase. [. . . ]