User manual TOSHIBA EQUIUM A110

[. . . ] Fujitsu and the Fujitsu logo are registered trademarks, and LifeBook is a trademark of Fujitsu Limited. Built for Humans is a trademark of Fujitsu PC Corporation. The following are registered trademarks of IBM Corporation:IBM, IBM PC AT, IBM PS/2. The following are registered trademarks of Microsoft Corporation:MS, MS-DOS, Windows, Windows 95, Windows NT. [. . . ] (See page 61. ) Table 4-13 shows the names of the menu fields for the Security menu, all of the options for each field, the default settings and a description of the field's function and any special information needed to help understand the field's use. The default condition is no passwords required and no write protection. Figure 4-13 Security Menu 96 LifeBo ok L Series from Fuji tsu Con fi gu r i n g You r Li feB ook L Se r i es Table 4-13 Fields, Options and Defaults for the Security Menu Menu Field Supervisor Password is: User Password is: Set Supervisor Password: Options -- -- [Enter] Default Clear Clear -- Description A display-only field. Set is displayed when the system supervisor password is set and Clear when it is not. Set is displayed when the general user password is set, and Clear when it is not. Sets, changes or cancels the Supervisor Password. The Supervisor Password may be up to seven characters long and must include only letters or numbers. To cancel a password press the Enter key instead of entering characters in the Enter New Password field and in the Re-enter New Password field. When a Supervisor Password is set it must be used to access the BIOS setup utility. (This field can only be accessed if the Supervisor Password is set. ) S ets, changes or cancels the User Password. The User Password may be up to seven characters long and must include only lower case letters or numbers. To cancel a password press the Enter key instead of entering characters in the Enter New Password and Re-enter New Password fields. (See page 61. ) Table 4-14 shows the names of the menu fields for the Power menu, all of the options for each field, the default settings and a description of the field's function and any special information needed to help understand the field's use. POWER MENU ­ SETTING POWER MANAGEMENT FEATURE CONTROLS POINT Most power management parameters can also be set from the Windows 95 or Windows NT 4. 0 desktop without entering the setup utility, using PowerPanel by Phoenix Technologies. Changing the settings with PowerPanel does not change what is stored in the CMOS memory. (See pages 52-55. ) 100 Figure 4-14 Power Menu POINT In Windows 98 Auto-Suspend Timeout, Hard Disk Timeout, and Video TImeout features are available exclusively through the operating system. LifeBo ok L Series from Fuji tsu Con fi gu r i n g You r Li feB ook L Se r i es Table 4-14 Fields, Options and Defaults for the Power Menu. Menu Field Power Savings: Options Customized; Maximum Performance; Maximum Power Savings, Disabled. Default [Customized] Description Sets the power savings parameters to a factory installed combination of parameters, a custom set of parameters set by you or no power saving features. Sets the length of time that the hard drive can be inactive before your notebook automatically turns off the power to the hard drive controller and drive motor. If you choose a factory installed combination of parameters this field will display the setting. If you choose to customize the parameters you will be able to set this yourself. The options available vary from Off, which has no inactivity shutoff, to 20 minutes. Sets the length o f time without any user input d evice activity before the display is turned off. If you choose a factory combination of parameters, this field will display the setting. [. . . ] 4, 46-47, 52-55, 59, 100, 151-152, 156, 169, 175 PowerPanel toolbar. 4, 15, 17, 19-21, 25, 43, 50, 162, 164, 175 Presentation profile . 20, 44, 50-53, 59-60, 118, 141, 160, 162-166, 177-181 Quiet boot . 3, 46, 130, 136, 158, 160, 172, 177, 181-182 Real time clock . [. . . ]