User manual TOSHIBA FT3806

[. . . ] Do not use this product near water sources, such as bath tubs, wash bowls, kitchen sinks, laundry tubs, wet basements, or swimming pools. Do not place this product on an unstable cart, stand, or table. The telephone may fall, causing serious damage to the telephone. Slots and openings in the cabinet and the back or bottom are provided for ventilation, to protect the phone from overheating. [. . . ] SETTING UP THE BASE UNIT For use on a desk or counter top follow the instructions below. DESKTOP MOUNTING: Fasten the AC adaptor cord to prevent it from being disconnected. Raise the antenna to vertical position. Single-Line Telephone Jack (RJ11C) Telephone Line Cord Power Outlet (AC 120V, 60Hz) AC Adaptor · USE ONLY WITH Supplied AC ADAPTOR (TAC-8001); power source AC 120V, 60Hz/DC 9V). · The AC adaptor must remain connected at all times. (It is normal for the adaptor to feel warm during use). 5 2. CHARGE THE BATTERY PACK Note Red Black Use only the supplied battery pack (TRB-8000 power source 600 mAh, 3. 6V). q Remove the battery compartment cover on the back of the handset by sliding it down. w Plug the battery pack cord into the connector in the battery compartment by observing the correct polarity. e Place the battery pack in the battery compartment. r Put the battery compartment cover back by sliding until it snaps into place. Make sure not to get the wires of the battery pack caught in the cover. If the IN USE/CHARGE LED does not light, make sure the AC adaptor is plugged in securely and that the electrical outlet is working and not controlled by a light switch. It is important to charge the battery for 12 to 16 hours continuously without any interruption before you use the handset for the first time. 90 0M Hz Charging contacts IN USE/ CHARGE LED Note The battery pack is not charged properly if the charging contacts are dirty or tarnished. The TALK/BATT LOW LED turns off. 3 2. To stop paging, press PAGE or any key at the handset, or return the handset to the base unit. Note You cannot page the handset during a call. 11. OUT OF RANGE During a call, as you begin to move too far from the base, you first hear a clicking sound. As you travel farther, the noise increases. Then you should move close to the base unit. If you travel out-of-range, your call terminates. 13 MEMORY DIALING You can store up to 10 telephone numbers in memory. Notes In memory dialing operation, · If more than 20 seconds elapse between pressing buttons, the operation will be cancelled and you must start over again. · If you press a wrong button, an error tone sounds and the handset returns to standby mode. · If a call comes in, the operation will be cancelled and you will hear the ring. 1. STORING NUMBERS You can store up to 16 digits including #, address. and PAUSE in one memory TALK q Pick up the handset from the base unit. (Do not press MEM ). e Dial the telephone number you wish to store (up to 16 digits). MEM t Enter the memory address (0 to 9) at which you wish to store the phone number dialed in step 3. [. . . ] · The handset is not on the base. Place the handset on the base properly · The handset is too far from the base unit. Place the handset on the base unit to recharge. · The base unit is located in a place with high interference. [. . . ]