User manual TOSHIBA FT6004BK

[. . . ] Do not use this product near water sources, such as bath tubs, wash bowls, kitchen sinks, laundry tubs, wet basements, or swimming pools. Do not place this product on an unstable cart, stand, or table. The telephone may fall, causing serious damage to the telephone. Slots and openings in the cabinet and the back or bottom are provided for ventilation, to protect the phone from overheating. [. . . ] SETTING UP THE BASE UNIT For use on a desk or counter top follow the instructions below. DESKTOP MOUNTING: Raise the antenna. to vertical position. Fasten the AC adaptor cord to prevent it from being disconnected. Telephone Line Cord Single-Line Telephone Jack (RJ11C) Power Outlet (AC 120V, 60Hz) AC Adaptor · Plug the AC adaptor firmly into the base unit and the AC 120V outlet. · USE ONLY WITH Supplied AC ADAPTOR (TAC-1700 power source AC 120V, 60Hz/DC 9V). · The AC adaptor must remain connected at all times. (It is normal for the adaptor to feel warm during use. ) 5 2. CHARGE THE BATTERY PACK Note Red Black Use only the spplied battery pack (TRB-8000; power source 600 mAh, 3. 6V). q Remove the battery compartment cover on the back of the handset by sliding it down. w Plug the battery pack cord into the connector in the battery compartment in correct polarity. e Place the battery pack in the battery compartment. r Put the battery compartment cover back by sliding until it snaps into place. Make sure not to get the wires of the battery pack caught in the cover. If the IN USE/CHARGE LED does not light, make sure the AC adaptor is plugged in securely and that the electrical outlet is working and not controlled by a light switch. · Pressing the VOL/RING (w or v) button of the handset also controls the connected headset's volume. · If you place the handset on the base unit while the headset is connected, be sure the handset is placed properly. 13 MEMORY DIALING You can store up to 10 telephone numbers in memory and 3 telephone numbers in speed-dial. Notes In memory dialing operation, · If more than 20 seconds elapse between pressing buttons, the operation will be cancelled and you must start over again. · If you press a wrong button, an error tone sounds and the handset returns to standby mode. · If a call comes in, the operation will be canceled and you will hear the ring. 1. STORING NUMBERS You can store up to 20 digits including #, address. and PAUSE in one memory TALK q Pick up the handset from the base unit. (Do not press MEM . ) e Dial the telephone number you wish to store. (up to 20 digits). MEM t Enter the memory address (0 to 9) or ONE-TOUCH DIAL key ( MEM1 , MEM2 , MEM3 ) at which you wish to store the phone number stored in step 3. You will hear a long beep when the number is successfully stored. To store more telephone numbers, repeat the steps from w to t. u Record the telephone numbers on the SPEED DIAL INDEX CARD, and place it on the back of the handset. [. . . ] Plug the AC adaptor firmly into the base unit and AC 120V outlet. · The handset is not on the base. Place the handset near the base properly. · The handset is too far from the base unit. [. . . ]