User manual TOSHIBA FT6505

[. . . ] PQJA212V (Black) PQJA212M (White) one Telephone Line Cord (p. PQKL10038Y3 (Black) PQKL10038Y1 (White) one one 2 Contents Preparation Location of Controls . 15 Connecting the Handset/Telephone Line Cord . 19 Preparation Basic Operation Making Calls . [. . . ] Only incoming calls are accepted until the dial lock is canceled. Before using this feature, we recommend storing an emergency number in the memory of the EMERGENCY button (p. (EMERGENCY) Even if the dialing buttons are locked, the number stored in the button can be dialed. If you choose not to program emergency numbers, but plan to use the dial lock, any number programmed into the EMERGENCY button can be accessed. To set the dial lock M IC 1 2 3 Press (DIAL\LOCK). The MUTE indicator flashes. Enter the PIN code (p. 19). Press (PROGRAM). A long beep sounds. If a wrong PIN code is entered, 3 beeps will sound. Enter a correct PIN code and press (PROGRAM). The unit will return to the standby mode. You can use the following features while the dialing buttons are locked. Dialing a number you programmed into the memory of the EMERGENCY button (p. 16) Adjusting the handset and speakerphone volumes (p. 18) Answering the second call by pressing (FLASH) (p. 17) To cancel the dial lock Follow steps 1 through 3 above again. 20 Call Restriction You can prevent the unit from dialing phone numbers beginning with specified digit(s) (1 digit or 2 digits). (MUTE) may have been pressed during the conversation. Programming is not possible when a call is put on hold. Do not pause for over 60 seconds while programming. Programming is not possible when a call is put on hold. Check that the batteries are installed in the unit and that the battery power is not low. Do not enter a phone number more than 22 digits long. 21), you cannot store a phone number in the EMERGENCY button. To answer the call, lift the handset or press (SP-PHONE/HEADSET). Start again from the beginning after hanging up. If the last number dialed was more than 32 digits long, the number will not be redialed correctly. The unit does not ring. You cannot dial. The other party suddenly cannot hear your voice during a conversation. [. . . ] Remain on the line and briefly explain to the dispatcher the reason for the call before hanging up. Perform such activities in the off-peak hours, such as early morning hours or late evenings. For assistance, please call: 1-800-211-PANA(7262) 29 Useful Information " FCC and Other Information This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CAUTION: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this device. [. . . ]