User manual TOSHIBA IK-TU40A

[. . . ] For more detailed information about the take-back and recycling of this product, please contact your supplier where you purchased the product or consult. Unit : mm [inch] Rear 20 [0. 79] Lens (option) Camera head Camera Cable (option) IK-TF7U (option) Camera control unit Cable (option) DC IN 12V Flange face Rear projection less than 4mm (0. 157") DC power supply (option) When connecting the camera cables, be sure to turn off the camera control unit and the other equipment connected. We suggest that a c-mount lens designed specially for 3CCD cameras is used. When using other lens, the best camera performance of this camera may not be obtained. (For example, low resolution may occur, focus may be lost through the range of a zoom lens, and flare, ghost or shading may occur) Furthermore, to avoid damaging the camera, use a lens which has a rear projection from the flange face of less than 4mm (0. 157"). [. . . ] One (1) Year Limited Warranty of Labor and Parts ISD warrants that this Product will perform in accordance with specifications for a period of one (1) year from the date of purchase by the Original End-User. During this one (1) year period, ISD will repair or replace the Product, if it does not perform as warranted. In order to take advantage of this Limited Warranty, You must: (a) deliver the Product to an ISD Authorized Service Provider ("ASP"); and (b) pay all transportation and insurance charges for shipment of the Product to the ASP. ISD reserves the right to substitute factory refurbished parts in place of those in need of repair. Instruction Manual (Owner's Manual): You should read the Instruction Manual (Owner's Manual) thoroughly before operating this Product. Before seeking warranty service, you should check the troubleshooting guide in the Instruction Manual (Owner's Manual) and follow the instructions to correct the problem. Your Responsibilities This Limited Warranty is subject to the following conditions: 1. You must provide the bill of sale or proof of purchase at the time that warranty service is required. You must notify an ASP within thirty (30) days after You discover that the Product does not perform in accordance with specifications during the Limited Warranty period. All warranty servicing of this product must be made by an ISD Authorized Service Provider. You must pack the Product in its original carton using the original packing material, then insert the original carton containing the Product into another carton with additional packing material before shipping the Product to an ASP. Please also note that transfer of an image or file covered by copyright is restricted to use within the scope permitted by the Copyright Law. PROTECTION OF PERSONAL INFORMATION Images taken by the camera that reveal the likeness of an individual person may be considered personal information. To disclose, exhibit or transmit those images over the internet or otherwise, consent of the person may be required. LIMITATION OF USAGE The product is not designed for any "critical applications. " "Critical applications" means life support systems, exhaust or smoke extraction applications, medical applications, commercial aviation, mass transit applications, military applications, homeland security applications, nuclear facilities or systems or any other applications where product failure could lead to injury to persons or less of life or catastrophic property damage. Accordingly, [Toshiba/TAIS] disclaims any and all liability arising out of the use of the product in any critical applications. CAUTIONS ON USE AND INSTALLATION Handling the unit. Do not drop, jolt, or vibrate, as this may result in damage to the unit. Treat the camera cables carefully to prevent cable problems, such as breaks in the cable and loose connections. Install the camera in a location free from noise. If the camera or the cables are located near power utility lines or a TV, etc. undesirable noise may appear on the screen. In such a case, try to change the location of the camera or the cable wiring. Operating ambient temperature and humidity. Do not use the camera in places where temperature and humidity exceed the specifications. [. . . ] Ghosts may occur when there is an intense light near the object. In this case, change the shooting angle. Moire A moire pattern is an interference pattern generated when two repetitive line patterns overlap. Eliminating the repetitive line patterns, or aligning the two patterns, will eliminate the moire. [. . . ]