User manual TOSHIBA IP5000 QUICK REFERENCE GUIDE

[. . . ] Lift the handset off-hook / on-hook to save the settings. From the IP Configuration screen, press the Others softkey. Press Set softkey twice to return to the IP Configurations screen. Lift the handset off-hook / on-hook to save the settings. 4 Strata CIX IP5000-series Telephone Quick Reference Guide 05/08 Backlight On / Off To change Backlight Settings For the 4-line LCD telephones: 1. [. . . ] Press CALL to dial the number. Call Forward - Any Calls (Internal & External) Enter the button sequence below All Calls: Press Ext. + #6011 + Destination Number Busy: Press Ext. + #6021 + Destination Number No Answer: Press Ext. + #6031 + Destination Number + Timer (seconds, 2-digits) + # Busy No Answer: Press Ext. + #6041 + Destination Number + Timer (seconds, 2-digits) + # Cancel: Press Ext. + #6051 Call Park Orbits To park a call 1. Specify the Park Orbit using one of the following: · Press * and the system automatically selects a General Park Orbit between 7000~7019. Press # and the system automatically selects your extension as the orbit. · · 3. If the parked call is not retrieved, the call rings back to your phone. Enter the Orbit Number where the call is parked. Strata CIX IP5000-series Telephone Quick Reference Guide 05/08 7 Call Transfer Simple Transfer 1. Dial the extension number and the call is transferred. If your telephone doesn't have a display, or if you would like to announce the call 1. (Optional: Stay on the line to announce the call). Note During call transfer you can reconnect to the original caller by pressing your flashing extension button. Conference Calls 1. When the called party answers, press Cnf/Trn. Note If you receive a busy tone or if the station does not answer, press the flashing line button to return to the original call. To transfer conference control Note When the person who initiates the conference (master) hangs up, control transfers to the first internal station added to the conference. If no internal stations are in the conference, the call disconnects. Perform Steps 1 and 2 above to add the line to which you wish to transfer conference control. Announce the call and hang up to transfer the call. This station is now the conference "master" with the ability to add or delete parties. To hold a conference call If you are the "master" conference controller, press Hold once (or twice for Executive Hold) to place the conference call on hold. [. . . ] Repeat steps 2~5 to add more speed dial numbers. To end programming session, lift and replace the handset. To clear a number from a Station Speed Dial code Repeat the previous procedure skipping Step 4. Press Spdial, then dial the Speed Dial Number. Note You may need to lift the handset and access an outside line before pressing Spdial (depending on your telephone setup). CAUTION! [. . . ]