User manual TOSHIBA MA-156-1

[. . . ] TEC Electronic Cash Register MA-156-1 SERIES Owner's Manual Table of Contents NOTICE This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. [. . . ] Returned Merchandise/Void Key: Used inside a sale to delete items already entered in the current sale. When outside a sale, it is used to refund money to a customer who has returned items already purchased. Non-add Number Print/Received-on-Account Key (X Mode): When depressed with a prior number entry, it function as Non-add Number Print Key. When used in X mode, it functions to record received-on-account payment amounts. No-sale/Paid Out Key (X Mode): Used outside a sale to open the drawer without relating to a sale. When used in X mode, it functions to record amounts paid out of the drawer without relating to a sale. PLU (Price-Look-Up) Key: Used to enter a PLU which is linked to a department. Dollar Discount Key: Used to subtract an amount from the sale such as a discount. TAX % ST CH AT/TL CHK VD # RA NS PO PLU - -8- EO1-11099 8. Installing the Paper Roll WARNING! Care must be taken not to injure yourself with the paper cutter. SET OFF REG X Z 1 Set the Mode Select Switch to REG positon. 2 To remove the Printer Cover, insert the Printer Cover/Drawer Key to the Printer Cover Lock, and then Turn it 90° clockwise. 3 Cut the paper end to make it sharp. 4 Hold the paper roll so that the paper end will be fed from the bottom. -9- EO1-11099 5 Place the paper roll in the paper pocket. 6 Insert the paper end into the Paper Inlet located on the rear side of the printer, and hold down the [FEED] key on the keyboard until the paper end comes out of the outlet. 7 If the printer is used for journal, fold the top end of the paper and insert the folded end into the slit of the Take-up Reel. Then wind the paper two or three times, set the reel to the holder, and hold down the [FEED] key for a while to tense the paper. If the printer is used for receipts, do not wind the paper end around the Journal Take-up Reel. - 10 - EO1-11099 8 If the printer is used for journal, simply attach the Printer Cover. The Receipt Outlet is used as Journal Window. If the printer is used for receipts, attach the Printer Cover with the paper end coming out of the Receipt Outlet located on the Printer Cover. 9. Programming The time and date should be adjusted and such data as status of each department, percent rate, etc. should be programmed before starting sale entries. Printing occurs as programming is proceeded. · The programmed data will be retained by dry batteries even if the power of the machine is turned OFF or a power failure occurs. · Set the Mode Select Switch to the SET position before starting any programming operation. · Key indications in the operation patterns in this manual: SET OFF REG X Z . . . . . . . . . . . . . . . . . . . Entry through a Numeric Key . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Function Key depression - 11 - EO1-11099 System Option Setting (Available after the Financial Reset (Z) Report is taken. ) ST HALC for tender amount of the [CHK] key 1 to 7 (NOTE 1 on the next page) Date Entry Order 0 : Day-Month-Year 1 : Year-Month-Day 2 : Month-Day-Year Time Print 0 : Print 1 : Non-print GT Print Even Number: Non-print Odd Number: Print The First Decimal Place Rounding Process 0 or 1 : Round Off 2 or 3 : Round Up 4 or more : Round Down Credit Balance (NOTE 2 on the next page) 0 : Prohibited 1 : Allowed Use of the [CHK] key 0 : Total & Tender Functions 1 : Total Function only 2 : Tender Function only Use of the [%] key 0 : %1 : %+ Use of the Printer 0 : Journal 1 : Receipt - 12 - EO1-11099 NOTES: 1. HALC (High Amount Listing Capacity) is used to check excessively high amounts entered by mistake. For example, if "3" is entered, it means 3 digits and the high amount limit is 999 ($9. 99). Credit Balance means that amount entries through the [ - ] key will result in over-subtraction of the subtotal amount at the time of the entry through this key. If the status "Allowed" is selected, over-subtraction using the [ - ] key will be allowed. [. . . ] 8 Sales: Item Count Amount Tax Total Net Sale with Tax: Item Count Amount %- Count Amount Dollar Discount Amount Total Customer Count Media Total Cash Sales: Customer Count Amount Check Sales: Customer Count Amount Charge or Credit Sales: Customer Count Amount Received-on-account Count Amount Paid Out Count Amount Cash-in-drawer Amount Check-in-drawer Amount Last Line Voiding Count Amount Returned Merchandise & Designated Line Voiding: Item Count, Amount Reset Counter Consecutive No. Time Date PLU Code 30 Sales:Count Amount Z Reset Counter - 38 - EO1-11099 14. Maintenance WARNING! Care must be taken not to injure yourself with the paper cutter. Replacing the Paper Roll 1 To remove the Printer Cover, insert the Printer Cover/Drawer key to the Printer Cover Lock, and then turn it 90° clockwise. 2 If the printer is used for Journal, hold down the [FEED] key to wind up the printed portion of paper, then cut the paper as shown in the figure. Hold down the [FEED] key again to advance the remaining paper end. If the printer is used for Receipt, cut the paper roll as shown in the figure. [. . . ]