User manual TOSHIBA MAGNIA SG20

[. . . ] YOU AGREE THAT TOSHIBA, ITS AFFILIATES AND SUPPLIERS SHALL HAVE NO RESPONSIBILITY FOR DAMAGE TO OR LOSS OF ANY BUSINESS, PROFITS, PROGRAMS, DATA OR REMOVABLE STORAGE MEDIA ARISING OUT OF OR RESULTING FROM THE USE OF THE PRODUCT, EVEN IF ADVISED OF THE POSSIBILITY THEREOF. Protection of Stored Data For your important data, please make periodic back-up copies of all the data stored on the hard disk or other storage devices as a precaution against possible failures, alteration, or loss of the data. IF YOUR DATA IS ALTERED OR LOST DUE TO ANY TROUBLE, FAILURE OR MALFUNCTION OF THE HARD DISK DRIVE OR OTHER STORAGE DEVICES AND THE DATA CANNOT BE RECOVERED, TOSHIBA SHALL NOT BE LIABLE FOR ANY DAMAGE OR LOSS OF DATA, OR ANY OTHER DAMAGE RESULTING THEREFROM. WHEN COPYING OR TRANSFERRING YOUR DATA, PLEASE BE SURE TO CONFIRM WHETHER THE DATA HAS BEEN SUCCESSFULLY COPIED OR TRANSFERRED. TOSHIBA DISCLAIMS ANY LIABILITY FOR THE FAILURE TO COPY OR TRANSFER THE DATA CORRECTLY. Critical Applications The computer you have purchased is not designed for any "critical applications. " "Critical applications" means life support systems, medical applications, connections to implanted medical devices, commercial transportation, nuclear facilities or systems or any other applications where product failure could lead to injury to persons or loss of life or catastrophic property damage. [. . . ] To ensure that the battery charges to its full capacity, wait until it reaches room temperature (50 to 80 degrees Fahrenheit, 10 to 26 degrees Celsius). The battery is almost completely discharged. Leave the power connected, and the battery should begin charging after a few minutes. 122 Mobile Computing Monitoring battery power Charging the RTC battery The computer contains an internal battery that provides power for the real-time clock (RTC) and calendar. During normal use, the main battery keeps the RTC battery adequately charged. Occasionally, the RTC battery may lose its charge completely, especially if you have had the computer turned off for a long time. If the RTC battery is low, the real-time clock and calendar may display the incorrect time and date, or stop working. To recharge the RTC battery, plug in the computer and leave it turned on for 10 hours or longer. NOTE: It is seldom necessary to charge the RTC battery because it charges while the computer is on. If the RTC battery is low, the real-time clock and calendar may display the incorrect time and date or stop working. When Hibernation mode is enabled and the RTC battery is completely discharged, a warning prompts you to reset the realtime clock. The computer can be used while the RTC battery is being charged, although the charging status of the RTC battery cannot be monitored. Monitoring battery power The battery light indicates the main battery's current charge. It: Glows green when the battery is fully charged Glows amber while the battery is being charged Does not glow if the external power source is disconnected or if the battery is completely discharged Mobile Computing Monitoring battery power 123 Determining remaining battery power NOTE: Wait at least 16 seconds after turning on the computer before trying to monitor the remaining battery power. The computer needs this time to check the battery's remaining capacity and perform its calculations. 1 2 3 Click Start, then click Control Panel. See "TOSHIBA Console" on page 192 or "Power Management" on page 194. 4 5 Choose the Power Save Modes tab, then under the Running on Batteries section, click Details. Click the Alarm tab and set the alarm, as desired. 126 Mobile Computing Changing the main battery Changing the main battery When your battery power is running low, you have two options: connect the computer to an AC power source or install a charged battery. NOTE: If your battery discharges fully, your information will be lost. Be sure to save your work often. CAUTION: When handling a battery, be careful not to drop it or short-circuit its terminals. Also, do not drop, hit or otherwise impact the battery. Do not scratch or break the casing and do not twist or bend the battery pack. Do not remove the battery pack while the computer is in Standby mode. Data in memory will be lost. Removing the battery from the computer 1 2 Save your work. Turn off the computer or place it in Hibernation mode according to the instructions in "Using Hibernation" on page 105. Remove all cables connected to the computer. [. . . ] telephone systems and direct-connect modems. The RJ11 connector is a 6wire connector. ROM (read-only memory) -- Non-volatile memory that can be read but not written to. By non-volatile, we mean that information in ROM remains whether or not the computer is receiving power. [. . . ]