User manual TOSHIBA MD20FL1

[. . . ] This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the distance between the equipment and receiver. [. . . ] Text: The text closed caption mode will usually fill the screen with a programming schedule or other information. After selecting a closed caption mode, it will stay in effect until it is changed, even if the channel is changed. If the captions signal is lost due to a commercial or a break in the signal, the captions will reappear when the signal is received again. If the channels are changed, the captions will be delayed approximately 10 seconds. The captions will appear in places on the screen where they will least interfere with the picture, usually on the bottom of the screen. News programs will usually show three-line closed captions which scroll onto the screen. Most other shows provide two or three lined captions placed near the character who is speaking so the viewer can follow the dialogue. Words in italics or underlined describe titles, words in foreign languages or words requiring emphasis. Words that are sung usually appear enclosed by musical notes. For television programs broadcasting with closed captions, look in your TV guide for the closed captions symbol (CC). TO VIEW CLOSED CAPTIONS Press CLOSED CAPTION to switch between normal TV and the two closed caption modes (captions and full screen text). Press / or / to select the desired item you want. CH + V-CHIP SET TV RATING MOVIE RATING CH ­ V-CHIP V-CHIP SET CHANGE PASSWORD OFF / / / / MENU / / / / ENTER/MENU 6 Press or to display "ON". Now your settings were set into the memory. VOL ­ VOL + V-CHIP V-CHIP SET CHANGE PASSWORD ON ENTER VOL ­ CH ­ RECALL VOL + 3 Press or to select "MOVIE RATING". / / / / MENU CH + CH ­ V-CHIP SET TV RATING MOVIE RATING TV-Y OFF 7 Press MENU repeatedly until the menu screen is cleared. SETUP/MENU / / / / ENTER/MENU To use after the TV is protected When the program applied to the V-Chip setting is received, enter the password, then press ENTER. Note: The V-Chip function is activated only on programs that have the rating signal. 25 5K50201A [E] (P24-27) 25 20/4/04, 15:42 TV operation Picture control adjustment / Adjusting the picture preference Picture controls are factory preset but you can adjust them individually as follows: And also you can select four picture modes--Standard, Sports, Movie, and Memory--as described in the following table: MENU CANCEL /// ENTER Picture control adjustment Adjusting the picture preference 1 2 Press MENU, then press option. SETUP/MENU or to select 1 Press MENU, then press option. SETUP/MENU or to select VOL ­ VOL + PICTURE PICTURE PREFERENCE VOL ­ VOL + PICTURE PICTURE PREFERENCE Press . or to select "PICTURE", then press / / / / MENU CH + PICTURE PICTURE PREFERENCE VOL + 2 Press or to select "PICTURE PREFERENCE", then press . CH + CH ­ / / / MENU CH ­ VOL + PICTURE PICTURE PREFERENCE 3 Press or to select the item you want to or to adjust the setting. adjust, then press / / / MENU CH + VOL ­ CH ­ VOL + BRIGHTNESS CONTRAST COLOR TINT SHARPNESS 0 +32 0 0 0 3 Press or to select the desired picture mode, then press ENTER. ENTER CH + / / / / CANCEL / MENU CH ­ PICTURE PREFERENCE STANDARD SPORTS MOVIE MEMORY Selection BRIGHTNESS CONTRAST COLOR TINT SHARPNESS Pressing darker lower paler reddish softer lighter higher deeper greenish sharper / / ENTER / MENU Mode STANDARD SPORTS MOVIE MEMORY Picture quality Standard picture quality (factory-set) Bright and dynamic picture (factory-set) Movie-like picture setting (factory-set) Your personal preferences (set by you; see "Picture control adjustment" as left) Note: The CONTRAST default setting is set to maximum (+32) at the factory. 4 26 After your desired setting press MENU repeatedly until the menu screen is cleared. SETUP/MENU 4 After your desired setting press MENU repeatedly until the menu screen is cleared. SETUP/MENU 3 To return all adjustments to the factory preset levels Press CANCEL while making picture adjustments. Note: You can not select "PICTURE PREFERENCE" in the Game mode. 5K50201A [E] (P24-27) 26 20/4/04, 15:43 Stereo and Second Audio Program (SAP) The TV/DVD is equipped with a feature known as multi-channel TV sound or MTS. MTS broadcasts greatly enhance TV viewing by bringing you programs with high fidelity stereo sound. MTS also provides an extra channel called the Second Audio Program or SAP which broadcasters can use to transmit a second language for bilingual transmission or for other purposes. AUDIO Listening to stereo sound When the TV is turned on or a channel selection is made, make certain the "STEREO" appears on the screen. This means that Stereo broadcasting is available. You can enjoy stereo sound from the left and right speakers. · When mono broadcasting is received, no indication is displayed. · If the broadcast signal is not strong enough or clear stereo sound is not available, press AUDIO to change to mono sound. Press it again to return to the stereo sound. To select desired sound Press AUDIO to select the desired sound. TV operation AUDIO SEL. [. . . ] You must also deliver the entire product to a TACP Authorized Service Station. You are responsible for all transportation for the set to and from the Service Station. Limited Two (2) Year Warranty of Picture Tube TACP further warrants the picture tube in this product against defects in materials or workmanship for a period of two (2) years after the date of original retail purchase. During this period, TACP will replace a defective picture tube without charge to you except that if a defective picture tube is replaced after ninety (90) days from the date of the original retail purchase, you pay labor charges involved in the replacement. You are responsible for all charges involved in the replacement. [. . . ]