User manual TOSHIBA RAS-13SKP-ES2 SERVICE MANUAL

[. . . ] SVM-10025 SERVICE MANUAL AIR CONDITIONER SPLIT WALL TYPE RAS-13SKP-ES2 / RAS-13SA-ES2 RAS-13SKP-ES2(HK) / RAS-13SA-ES2 February, 2010 FILE NO. SPECIFICATIONS CONSTRUCTION VIEWS 2-1 Indoor Unit 2-2 Outdoor Unit 3. 4. WIRING DIAGRAM SPECIFICATION OF ELECTRICAL PARTS 4-1 Indoor Unit 4-2 Outdoor Unit 5. 7. REFRIGERATION CYCLE DIAGRAM CONTROL BLOCK DIAGRAM OPERATION DESCRIPTION 7-1 7-2 7-3 7-4 7-5 7-6 7-7 7-8 7-9 Remote control Outline of Air Conditioner Control Description of Operation Mode Low-Temperature Limit Control One-Touch Operation Hi POWER Operation QUIET Operation ECO Operation COMFORT SLEEP Operation 7-10 FILTER Check lamp 7-11 Auto Restart Function 7-12 Self-Cleaning Operation 8. INSTALLATION PROCEDURE 8-1 8-2 8-3 8-4 8-5 8-6 8-7 Safety Cautions Installation Diagram of Indoor and Outdoor Units Installation Indoor Unit Outdoor Unit How to Set Remote Control Selector Switch Others -1- FILE NO. [. . . ] · A place which can bear the weight of the outdoor unit and does not allow an increase in noise level and vibration. · A place where the operation noise and discharged air do not disturb your neighbors. · A place which is not exposed to a strong wind. · A place free of a leakage of combustible gases. · A place which does not block a passage. · When the outdoor unit is to be installed in an elevated position, be sure to secure its feet. · An allowable length of the connecting pipe is up to 15 m. · An allowable height level is up to 6 m. · A place where the drain water does not raise any problem. 50 mm or more Do not put the drain hose end into water. Do not put the drain hose end in the drainage ditch. Fig. Put water in the drain pan and make sure that the water is drained out of doors. When connecting extension drain hose, insulate the connecting part of extension drain hose with shield pipe. Shield pipe CAUTION 1. Install the outdoor unit without anything blocking the air discharging. When the outdoor unit is installed in a place exposed always exposed to strong wind like a coast or on a high storey of a building, secure the normal fan operation using a duct or a wind shield. In particularly windy areas, install the unit such as to avoid admission of wind. Installation in the following places may result in trouble. · A saline-place such as the coast. · A place where high-frequency waves are likely to be generated as from audio equipment, welders, and medical equipment. Drain hose Inside the room Extension drain hose Fig. 8-4-17 CAUTION Arrange the drain pipe for proper drainage from the unit. Improper drainage can result in dew-dropping. This air conditioner has the structure designed to drain water collected from dew, which forms on the back of the indoor unit, to the drain pan. Therefore, do not store the power cord and other parts at a height above the drain guide. Wall Drain guide Strong wind Space for pipes Fig. Cut the pipe with a pipe cutter. Obliquity Roughness Warp (Unit : N·m) Outer dia. [. . . ] <Caution at assembling> · If the bearing is out from the housing, push it into the specified position and then incorporate it in the main body. Bearing Bearing base Motor band Screw ­ 55 ­ FILE NO. Part name Fan motor Procedures 1) Follow to the procedure till item . . . . 2) Loosen the set screw of the cross flow fan. 3) Remove two fixing screws of the motor cover and them remove the motor cover. [. . . ]