User manual TOSHIBA RAV-362CH-PE SERVICE MANUAL

[. . . ] SPECIFICATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . CONSTRUCTION VIEWS (EXTERNAL VIEWS) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . SYSTEMATIC REFRIGERATING CYCLE DIAGRAM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . WIRING DIAGRAM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] YES NO Check and correct circuit cabling such as cabling to compressor. NO Is compressor normal?(Is resistance between windings 0. 6 to 1. 2W?) NO YES Is not winding opened?NO Compressor error Replace YES Compressor error Replace Compressor error Replace Check IPDU P. C. Defect Replace [H03 error]/[17 error] Are cablings of power and current sensor normal?YES NO Check and correct circuit cables. Check IPDU. Defect Replace 58 [F06 error]/[18 error] Are connections of TE/TS sensor connectors of CDB CN604/CN605 normal?YES Are characteristics of TE/TS sensor resistance values normal?YES NO Correct connection of connector. NO Replace TE and TS sensors. Check CDB. Replace Defect * Refer to Characteristics-3. [F04 error]/[19 error] Is connection of TD sensor connector of CDB CN600 normal?YES Are characteristics of TD sensor resistance value normal?YES NO Correct connection of connector. NO Replace TD sensor. Check control P. C. NO Is the circuit detected by current sensor normal?YES NO Improve and delete the cause. Check and correct circuit cables. Check IPDU. Replace Defect 61 [P04 error]/[21 error] Is high-voltage protective operation by TE sensor normal?YES NO Is connection of cabling connector normal?YES NO Correct connection of cabling connector. Check TE sensor. Defect Replace Does cooling outdoor fan normally operate?YES Do not TD and TO sensors come off the detection part?YES Are characteristics of TD, TO, TC sensor resistance values normal?NO Correct coming-off. Replace TD, TO, and TC sensors. * Refer to Characteristics-3 and 4. Check CDB. Defect Replace 62 [97 error] (Central controller) NO Is X, Y communication line normal?YES Are connections between connectors CN02, CN03 of network adapter P. C. [. . . ] Cord heater installation work procedure No. 1 1-2 Photo / Explanatory diagram Procedure Remove each cabinet, inverter assembly, motor base assembly, and partition board assembly. * Do not damage the electric parts such as cables, connectors, etc. <Example for RAS-13JAVP-E> As shown in the left figure, remove the set of refrigeration cycle assembly from the outdoor unit base. [. . . ]