User manual TOSHIBA SATELLITE PRO 440 FIELD REPLACEABLE UNIT DOCUMENTATION

[. . . ] ErgoTrac is a trademark of Fujitsu PC Corporation. The following are registered trademarks of IBM Corporation: IBM, IBM PC AT, IBM PS/2. The following are registered trademarks of Microsoft Corporation: MS, MS-DOS, Windows 98 SE. PCMCIA is a trademark of the Personal Computer Memory Card International Association. [. . . ] The utility will remove the space allocation for the Save-to-Disk function and free that space for other use. If you have just installed a new Memory Upgrade Module, or have a read or write error while going into Save-to-Disk mode, you will need to reset your Save-to-Disk parameters. To reset the Save-to Disk parameters, use the procedure below. Resetting the Save-to-Disk Parameters: 1. From the Shut Down menu select the restart option. When the Fujitsu Logo appears on your screen press F8 immediately, before the Windows 98 banner appears on the screen. Safe mode command prompt only, then press Enter. At the c:\> prompt, type cd fujitsu, then press Enter. 7. At the c:\>fujitsu prompt, type phdisk / delete / file, then press Enter. The press any key to restart the computer. When the Fujitsu Logo appears on your screen press F8 immediately, before the Windows 98 banner appears on the screen. 10 At the c:\> prompt, type cd fujitsu, then press Enter. In this case there is no time limit. 48 LifeBook C Series from Fujitsu User Installable Features Replacing the Battery The battery is installed in the battery bay on the underside of your notebook. (See Figure 4-1. ) With the purchase of an additional battery, you can have a fully charged spare to swap with one that is not charged. To swap batteries, have a charged battery ready to install and follow the steps below: 1. Press the Power button to put the notebook into suspend mode. (Or shut down your notebook and disconnect the AC adapter if you wish to cold-swap. ) 2. Close your display and stand your notebook on it's right panel with the top facing you. Press down on the battery release panel and slide it way from you. Set your notebook down gently on it's top, with the left panel facing you. Slide the battery pack away from the connector until it stops. Place the charged battery flat into the bay with the bottom up and the release panel away from you, approximately one quarter inch away from the connector in the notebook. Slide the new battery onto the connector. [. . . ] In your Computer this refers to returning to active operation after having been in one of the suspension states. ROM Read Only Memory. A form of memory in which information is stored by physically altering the material. Data stored in this way can not be changed by your Computer and does not require power to maintain it. SDRAM Synchronous Dynamic Random Access Memory. [. . . ]